STARTING/CHARGING – Chrysler Sebring LX 1998 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Chrysler Sebring LX 1998

List of elements for Charging Wiring Diagram for Chrysler Sebring LX 1998:

• (eng harn, in breakout for pcm connector) s132
• (eng harn, in ign- ition coil break- out s133
• 2.4l
• 2.5l
• Asd rly ctrl
• Asd rly out
• Auto- matic shut down relay (in pdc)
• Bat- tery
• Body control module (in jb)
• Ccd bus (+)
• Ccd bus (-)
• Charging system warning lamp
• Charging system ind ctrl
• Computer data lines system
• Engine controls system
• Fuse 11 10a
• Fuse 20a
• Fusible link
• G102 (top of left front strut tower)
• G129 (left rear of transmission)
• Gen fld dvr
• Generator
• Hot in off, run or start
• Ign
• Instrument cluster
• Junction block
• K20
• Nca
• Power distri- bution system
• Power distribution center
• Powertrain control module (side of pdc)
• Red
• Red/tan
• S104
• S113
• S114 (engine harness, in injector breakout)
• S118 (engine harness, 2.4l: near engine starter motor break- out; 2.5l: near break- out for ect engine sensor) controls system

Starting Wiring Diagram for Chrysler Sebring LX 1998

List of elements for Starting Wiring Diagram for Chrysler Sebring LX 1998:

• (1998)
• (ex. 1998)
• A41
• Acc
• Battery
• Engine starter motor
• Engine starter motor relay (in pdc)
• Fuse 20a
• G102 (top of left front strut tower)
• Hd in
• Ignition switch
• K90
• Lock
• Off
• Pl in
• Power distribution center
• Powertrain control module (between air cleaner housing & pdc)
• Red
• Run
• S102
• Start
• Starter relay control
• Tan
• Tan/ red
• Transmission control module (on left front inner fender)