STARTING/CHARGING – Honda CR-V SE 2005 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Honda CR-V SE 2005

List of elements for Charging Wiring Diagram for Honda CR-V SE 2005:

• A18
• Alternator
• B10 alternator l signal
• B13 alternator fr signal
• B18 alternator c signal
• Battery
• Bus (ecu)
• Bus meter
• Charge
• Communication
• Cpu
• Driver circuit
• E10
• E13
• E15 eld unit input
• Ecm/pcm (behind right side of dash)
• Eld unit
• Fuse 100a
• Fuse 10a
• Fuse 7.5a
• G1 (at left side of eng compt)
• G201 (behind right side of front bumper)
• Gauge assembly
• Hot in on or start
• Ind
• Junction connector c103 (at rear of engine)
• K10
• Multiplex control unit
• Starting circuit
• T101
• Transmission
• Underdash fuse/relay box (behind left side of dash, right of steering column)
• Underhood fuse/ relay box (on left side of engine compt)
• Vss

Starting Wiring Diagram for Honda CR-V SE 2005

List of elements for Starting Wiring Diagram for Honda CR-V SE 2005:

• (not used)
• A/t
• Acc
• Battery
• Clutch interlock switch (on clutch pedal support)
• E11
• Eld unit
• Fuse 19 100a
• Fuse 20 50a
• Fuse 21
• G1 (at left side of engine compt)
• G101 (at left side of engine)
• G502 (under right side of dash)
• Ignition switch
• Lock
• M/t
• Off
• Start
• Starter
• Starter cut relay
• Starter motor
• Starter solenoid
• Transmission
• Transmission range switch (on lower rear of transaxle)
• Underdash fuse/relay box (behind left side of dash, right of steering column)
• Underhood fuse/relay box (on left side of engine compartment)