STARTING/CHARGING – Hummer H2 2007 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Hummer H2 2007

List of elements for Charging Wiring Diagram for Hummer H2 2007:

• (not used)
• Battery
• Battery cable junction block (at left side of engine)
• Battery ind
• Charge ind ctrl
• Class 2 serial data
• Computer data lines
• Data
• G100 (on left front frame body mount)
• G102 (at left front side of engine block)
• Gen field duty cycle sign
• Generator
• Hot in on or start
• Ign
• Ign 1 volt
• Ign e fuse 10a
• Instrument panel cluster
• Logic
• Pnk
• Power distribution system
• Powertrain control module (on left front of engine compt)
• Sp205 (in i/p harness, on left side of dash, near footwell courtesy lamp)
• Starter
• Underhood fuse block (at left side of engine compt, near battery)

Starting Wiring Diagram for Hummer H2 2007

List of elements for Starting Wiring Diagram for Hummer H2 2007:

• Acc
• B12
• Batt
• Battery
• Battery cable junction block (at left side of engine)
• C2 f3
• Class 2 serial data
• Crank fuse 10a
• Crank voltage
• D11
• D12
• Data link connector (dlc) (under left side of dash, below steering column)
• F11
• G100 (on left front frame body mount)
• G102 (at left front side of engine block)
• Generator
• Hot at all times
• Ign a fuse 40a
• Ign b fuse 40a
• Ign e fuse 10a
• Ignition switch
• Lock
• P/n
• Park/neutral position (pnp) switch (on left side of transmission)
• Pnk
• Power distribution system
• Powertrain control module (on left front of engine compt)
• Red
• Run
• Sp205 (in i/p harness, on left side of dash, near footwell courtesy lamp)
• Start
• Start enable rly ctrl
• Starter
• Starter relay
• Underhood fuse block (at left side of engine compt, near battery)