STARTING/CHARGING – Jeep Comanche Eliminator 1992 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Jeep Comanche Eliminator 1992

List of elements for Charging Wiring Diagram for Jeep Comanche Eliminator 1992:

• Automatic shutdown relay (in power distribution center)
• Battery
• Fuse 16 60a
• Fuse 8 60a
• G101 (right side fender shield)
• G117 (right rear of engine)
• Generator
• K20
• Nca
• Power distribution center (right side of engine compt)
• Power distributon system
• Red
• Single board engine controller (sbec)/ engine control unit (ecu) (left front corner of engine compt)

Starting Wiring Diagram for Jeep Comanche Eliminator 1992

List of elements for Starting Wiring Diagram for Jeep Comanche Eliminator 1992:

• 2.5l & m/t
• A/t
• Acc
• Battery
• Engine controls system
• Fuse f10 40a
• G101 (right side fender shield)
• G117 (right rear of engine)
• G120 (right side of engine)
• Gear selector switch
• Hot at all times
• Ignition switch
• Nca
• Off
• Power distribution center (right side of engine compt)
• Power distribution system
• Red
• Run
• Single board engine controller (sbec)/ engine control unit (ecu) (left front corner of engine compartment)
• Start
• Starter
• Starter relay (in power distribution center)
• T41
• Transmission control module (lower right side of instrument panel)