STARTING/CHARGING – Pontiac Sunfire SE 1997 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Pontiac Sunfire SE 1997

List of elements for Charging Wiring Diagram for Pontiac Sunfire SE 1997:

• (left front of engine compt.)
• (left lower i/p)
• (not used)
• (not used) s
• Bat
• Battery
• Cls/pcm fuse 10a
• Cluster fuse 10a
• Data line
• Data link connector (left side of i/p)
• Fuse block
• G100
• Generator
• Generator control
• Generator f terminal
• Hot at all times
• Hot in off or run
• Ign
• Instrument cluster
• Microprocessor
• Pnk
• Power distribution system
• Powertrain control module (right front corner of vehicle, behind fascia)
• Red
• S277
• Starter solenoid
• Tan
• Uart data line
• Volts indicator

Starting Wiring Diagram for Pontiac Sunfire SE 1997

List of elements for Starting Wiring Diagram for Pontiac Sunfire SE 1997:

• (left front of engine compt.)
• A/t
• Accy
• Battery
• Bulb test
• Clutch pedal position switch (left side of i/p)
• Engine compartment fuse/relay center
• G100
• Generator
• Hold- in coil
• Hot at all times
• Ignition fuse 50a
• Ignition switch
• Lock
• M/t
• Off
• Power distribution system
• Pull- in coil
• Red
• Red b
• Run
• S202
• Start
• Starter motor
• Starter solenoid
• Transaxle range switch (left rear of engine)