STARTING/CHARGING – Volkswagen Cabriolet Etienne Aigner 1991 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Volkswagen Cabriolet Etienne Aigner 1991

List of elements for Charging Wiring Diagram for Volkswagen Cabriolet Etienne Aigner 1991:

• (not used)
• A/c control module
• Fresh air blower
• Fresh air blower series resistor
• Fuse 10a
• Fuse 40a
• Fuse 5a
• Fuse panel c
• G43 (behind right kick panel)
• G47 (behind right kick panel)
• High pressure sensor (right front of eng compt, in high side refrigerant line)
• Hot at all times
• Recirculation flap motor
• Seats system
• T10k
• T16e
• T20c
• Vehicle electrical system control module

Starting Wiring Diagram for Volkswagen Cabriolet Etienne Aigner 1991

List of elements for Starting Wiring Diagram for Volkswagen Cabriolet Etienne Aigner 1991:

• (below left side of dash)
• (not used)
• 13a
• Brakelight switch (above brake pedal)
• Clutch vacuum vent valve switch (m/t) (above clutch pedal)
• Computer data lines system
• Cruise control switch
• Data link connector (under left side of dash)
• Fuse 10a
• Fuse 7.5a
• Fuse panel (behind left side of dash)
• G42
• Horns system
• Hot at all times
• Hot in on or start
• Interior lights system
• Motronic engine control module (ecm) (at base of windshield, in center of plenum)
• Multifunction steering wheel control module
• Nca
• Red
• Sound system
• Thirteenfold auxiliary relay panel (under left side of dash)
• Throttle position sensor/accel pedal position sensor (2.0l) accelerator pedal position sensor (1.8l)
• Throttle throttle position sensor (2.8l & 3.2l) (on throttle body)
• Throttle valve control module (on throttle body)
• W/ steering wheel controls
• W/o steering wheel controls