SUPPLEMENTAL RESTRAINTS — Audi A6 Quattro 2000 — SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraints Wiring Diagram for Audi A6 Quattro 2000

List of elements for Supplemental Restraints Wiring Diagram for Audi A6 Quattro 2000:

• (+)
• (-)
• (1 through 27 not used)
• (in rear of center console) (partial) data link connector (dlc)
• 1 (+)
• 2 (-)
• Acc
• Air bag control module (below front of center console)
• Air bag malfunction indicator lamp (mil)
• Air bag spiral spring/return spring w/slip ring
• Center rear seat belt tensioner igniter
• Central locking control module
• Driver side head air bag igniter (w/head air bag)
• Driver's seat belt tensioner igniter
• Driver's side air bag igniter
• Driver's side side air bag crash sensor
• Driver's side side air bag igniter
• Emergency flasher switch
• G900 (lower left "a" pillar)
• Hot at all times
• Ignition starter/ switch
• Instrument cluster
• Instrument cluster combination processor
• Interference filter
• Left rear seat belt tensioner igniter
• Left rear side side air bag igniter (w/rear side air bag)
• Lock
• Nca
• Note: shorting bridges on air bag control module close when module connector is disconnected from harness. shorting bridges connect pins: 33 & 34, 37 & 38, 41 & 42 43 & 44, 45 & 46, 47 & 48 49 & 50, 51 & 52
• Passenger side head air bag igniter (w/head air bag)
• Passenger's seat belt tensioner igniter
• Passenger's side air bag igniter 1
• Passenger's side side air bag crash sensor
• Passenger's side side air bag igniter
• Red
• Right rear seat belt tensioner igniter
• Right rear side side air bag igniter (w/rear side air bag)
• Run
• Solid state
• Start
• T32a