SUPPLEMENTAL RESTRAINTS
Supplemental Restraints Wiring Diagram (1 of 2) for Buick Lucerne CXL 2009
https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html
Automotive Electricians Portal FZCO
Automotive Electricians Portal FZCO
List of elements for Supplemental Restraints Wiring Diagram (1 of 2) for Buick Lucerne CXL 2009:
- (in body harness, approximately 42 cm (17 in) from breakout for yaw & lateral acceleration sensor) j370
- (in steering wheel) inflatable restraint steering wheel module
- (right side of dash) inflatable restraint i/p module
- (under right front
- Air bag fuse 11 10a
- Batt positive vol
- Case ground
- Computer data lines system
- Driver seat belt buckle
- Driver seat belt switch
- Ground
- High control
- Hot w/ ign relay energized
- Ign 1 vol
- Inflatable restraint sensing & diagnostic module (sdm) (under center console)
- Inflatable restraint steering wheel module coil (top of steering column)
- Left inflatable restraint front end sensor (left front of engine compt)
- Left inflatable restraint side impact module (left side of driver's seat back)
- Left inflatable restraint side impact sensor (sis) (base of left "b" pillar)
- Low control
- Low reference
- Low speed
- Nca
- Passenger's seat) g302
- Pin shorting bars engaged
- Pnk
- Pnk/ red
- Pnk/red
- Right inflatable restraint front end sensor (right front of engine compt)
- Right inflatable restraint seat position sensor (sps) (on front passenger's seat left seat rail)
- Right inflatable restraint side impact module (right side of front passenger's seat back)
- Right inflatable restraint side impact sensor (sis) (base of right "b" pillar)
- Sensor signal
- Sensor voltage
- Shorting bar
- Stage 1
- Stage 2
- Switch signal
- Tan
- Tan/ pnk
- Tan/pnk
- Underhood fuse block (on right front of engine compt, forward of strut tower)
- When module connector is disconnected from harness: (shorting bars are connected between following pins: 4-5, 6-7, 8-9, 10-11, 14-15, 20-21, 22-23 & 26-27)
- X207 a1
- X211
Supplemental Restraints Wiring Diagram (2 of 2) for Buick Lucerne CXL 2009
List of elements for Supplemental Restraints Wiring Diagram (2 of 2) for Buick Lucerne CXL 2009:
- (left rear of luggage compt) g402
- (under driver's seat) g300
- Air bag ind
- Batt positive vol
- Belt tension sensor
- Computer data lines system
- Driver seat belt pretensioner
- Gmlan (sdm)
- Ground
- Hot at all times
- Ign
- Inflatable restraint i/p module indicator
- Inflatable restraint passenger presence system (pps) module (under front passenger's seat)
- Inflatable restraint passenger presence system (pps) sensor (under right side of front passenger's seat)
- Inflatable restraint seat belt tension sensor
- Instrument panel cluster (ipc)
- J312
- Left inflatable restraint roof rail module (if equipped) (left roof rail)
- Logic
- Low reference
- Nca
- Off ind
- On ind
- Pass air bag off ind ctrl
- Pass air bag on ind ctrl
- Pass seat belt ind
- Passenger air bag ind
- Passenger seat belt buckle
- Passenger seat belt pretensioner
- Pnk
- Pnk/ red
- Pnk/red
- Pnk/tan
- Rear fuse block (below left side of rear seat)
- Right inflatable restraint roof rail module (if equipped) (right roof rail)
- Sdm fuse 30 10a
- Seat belt ind
- Sensor signal
- Serial data
- Shorting bar
- Tan
- Tan/pnk
- Voltage reference