SUPPLEMENTAL RESTRAINTS – Buick Regal GS 2004 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraints Wiring Diagram for Buick Regal GS 2004

List of elements for Supplemental Restraints Wiring Diagram for Buick Regal GS 2004:

• (driver seat adjuster wiring harness, 20 cm from c311 breakout) s330
• (inside left door sill, forward of left front seat) g301
• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag fuse 10a
• Air bag warning indicator
• B11
• Body control module (bcm) (behind left side of dash, left of steering column)
• Case ground
• Class 2 (bcm) serial data
• Data link connector (dlc) (partial) (under left side of dash, right of steering column)
• G200 (behind right side of i/p compartment)
• Ground
• High control
• Hot in run, bulb test & start
• I/p fuse block (behind right side of dash, in right door opening)
• If equipped
• Ignition
• Ignition voltage
• Inflatable restraint i/p module
• Inflatable restraint sensing & diagnostic module (sdm) (below carpet, under right front seat)
• Inflatable restraint steering wheel module
• Inflatable restraint steering wheel module coil
• Instrument cluster
• Ipc class 2 serial data
• Left front inflatable restraint side impact module
• Left front inflatable restraint side impact sensor (at base of left "b" pillar)
• Logic
• Low control
• Nca
• Powertrain control module (pcm) (left front side of engine compartment, in air cleaner assembly)
• Seat belt switch
• Seat belt switch (part of driver's seat belt assembly)
• Serial data class 2
• Shorting bar
• Signal
• Solid state
• Splice pack sp205 (behind data link connector)
• Voltage