SUPPLEMENTAL RESTRAINTS – Buick Regal LS 2002 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Buick Regal LS 2002

List of elements for Supplemental Restraint Wiring Diagram for Buick Regal LS 2002:

• (driver seat adjuster wiring harness, approximately 20 cm (8 inches) from 6 pin in-line connector, below driver's seat) s330
• (inside left door sill, forward of left front seat) g301
• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag fuse 10a
• Air bag warning indicator
• B11
• Body control module (bcm) (behind left side of dash, left of steering column)
• Case ground
• Data link connector (dlc) (partial) (under left side of dash, right of steering column)
• Fuse block (behind right side of dash, in right door opening)
• G200 (behind right side of i/p compartment)
• Ground
• High control
• Hot in run, bulb test & start
• If equipped
• Ignition
• Inflatable restraint i/p module
• Inflatable restraint sensing & diagnostic module (sdm) (below carpet, under right front seat)
• Inflatable restraint steering wheel module
• Inflatable restraint steering wheel module coil
• Instrument cluster
• Left front inflatable restraint side impact module
• Left front inflatable restraint side impact sensor (at base of left "b" pillar)
• Low control
• Nca
• Powertrain control module (pcm) (left front side of engine compartment, in air cleaner assembly)
• Seat belt switch
• Seat belt switch (part of driver's seat belt assembly)
• Serial data class 2
• Shorting bar
• Signal
• Solid state
• Splice pack sp205 (below dash, right side of steering column, below data link connector)
• Voltage