SUPPLEMENTAL RESTRAINTS – Chevrolet Blazer 1997 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Blazer 1997

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Blazer 1997:

• (806)
• (dash harn, near breakout to airbag mod) s260
• (dash harn, near grommet at left rear of eng compt) s233
• A/t
• A10
• A11
• A12
• Air bag fuse 22 10a
• Air bag warning lamp
• Arming sensor (left side frame rail, near center crossmember)
• B10
• B11
• B12
• Clutch pedal position switch (on pedal support)
• Crank fuse 20 10a
• Crank input
• Data link connector (behind left side of i/p)
• Diagnostic energy reserve module (derm) (behind right kick panel)
• Diagnostic requst in
• Driver 36 vlr
• Driver sense high
• Driver sense low
• Driver source sense
• G112 (left side of engine)
• G114 (left rear of engine)
• Gauges fuse 4 10a
• Ground
• Hot in run, bulb test or start
• Hot in start
• I/p fuse block
• Ignition
• Instrument cluster
• Left forward discriminating sensor (left side of lower radiator support)
• M/t
• Nca
• Pnk
• Redundant indic, ign
• Right forward discriminating sensor (right side of lower radiator support)
• S213 (i/p harn, near breakout to cigar lighter)
• S232 (dash harn, near grommet at left rear of eng compt)
• S244 (dash harn, right of steering column)
• S245 (dash harn, right of steering column)
• Safety belt switch
• Seat belt monitor
• Shorting bar
• Sir coil assembly (top of steering column)
• Sir indic low
• Starting/charging system (starter relay)
• Steering wheel inflator module (mounted on steering wheel)
• Tan
• Warning systems (audio alarm)