SUPPLEMENTAL RESTRAINTS – Chevrolet Cavalier 2000 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Cavalier 2000

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Cavalier 2000:

• (at left front of passenger compartment) g309
• (in body harness, approximately 143 cm (55 inches) from left tail/stop lamp connector) s330
• 10,000 ohms
• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag indicator
• Aux disc sens input
• Bcm/clu fuse 10a
• Body computer module (bcm) (behind left side of dash)
• Case ground
• Data link connector (dlc) (partial) (below left side of dash)
• Driver side high
• Driver side low
• Electronic brake control module (next to master cylinder)
• Fuse block (behind lower left side of dash)
• Hot in accy, run & start
• Hot in run, bulb test or start
• Ignition
• Inflatable restraint front end discriminating sensor
• Inflatable restraint i/p module
• Inflatable restraint steering wheel module
• Inflatable restraint steering wheel module coil
• Instrument panel cluster (ipc)
• Nca
• Pass side high
• Pass side low
• Pnk
• Powertrain control module (pcm) (on right front of engine compartment)
• Seat belt sw input
• Seat belt switch (in driver seat belt assembly)
• Sensing & diagnostic module (sdm) (below right front seat)
• Sensor return
• Serial data class 2
• Shorting bar
• Sir fuse 15a
• Switched ignition