SUPPLEMENTAL RESTRAINTS – Chevrolet Monte Carlo SS 2000 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Monte Carlo SS 2000

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Monte Carlo SS 2000:

• (behind carpet, between left "a" pillar & "b" pilar) g309
• (driver seat adjuster wiring harness, approximately 20 cm (8 inches) from 8 pin connector, below driver's seat) s330
• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag warning indicator
• Case ground
• Data link connector (dlc) (partial) (below left side of dash, right of steering column)
• Driver frontal high
• Driver frontal low
• Driver sensor
• Driver sensor rtn
• Driver side high
• Driver side low
• F10
• G309 (behind carpet, between left "a" pillar & "b" pillar)
• Ground
• Hot in run, bulb test & start
• If equipped
• Ignition
• Inflatable restraint i/p module (on right side of dash, above glove box)
• Inflatable restraint sensing & diagnostic module (below passenger's seat)
• Inflatable restraint steering wheel module
• Inflatable restraint steering wheel module coil
• Instrument cluster
• Left front side inflatable restraint impact module (on left side of driver's seat seatback)
• Left i/p accessory wiring junction block (end of dash in left door opening)
• Left i/p accessory wiring junction block (end of dash, in left door opening)
• Left inflatable restraint side impact sensor (on left "b" pillar)
• Nca
• Pass frontal high
• Pass frontal low
• Sdm fuse 10a
• Seat belt switch
• Serial data class 2
• Shorting bar
• Solid state
• Splice pack sp205 (next to left i/p accessory wiring junction block wiring harness, taped on harness)