SUPPLEMENTAL RESTRAINTS – Chevrolet Tracker 2000 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Tracker 2000

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Tracker 2000:

• (behind dash, left of steering column)
• (i/p harn) s260
• (i/p harness) s250
• (i/p harness) s300
• (inside rear door) g410
• 15a
• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag fuse (in sir harness)
• Air bag ind
• Computer data lines system
• Data link connector (dlc) obd-ii (partial) (below left side of dash)
• Dr frnt high
• Dr frnt low
• G206 (behind center of dash)
• Ground
• Hot in on & start
• Ig fuse 20a
• Ignition
• Ind ctrl
• Inflatable restraint i/p module
• Inflatable restraint sensing & diagnostic module (sdm) (below front of center console)
• Inflatable restraint steering wheel module
• Inflatable restraint steering wheel module coil
• Instrument cluster
• Junction block (in left kick panel)
• Nca
• Note: a shorting bar is used on inflatable restraint sensing & diagnostic module module between pins a9-a18
• Pass fnt high
• Pass frnt lo
• Seat belt ind
• Seat belt sw
• Seat belt switch (open w/seat belt buckled) (in seat belt buckle)
• Serial data
• Shorting bar
• Sir data link connector