SUPPLEMENTAL RESTRAINTS – Chevrolet Venture LS 2001 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Venture LS 2001

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Venture LS 2001:

• (body harness, front of right "b" pillar approximately 26 cm (10 inches) from inflatable restraint sensing & diagnostic module breakout) s303
• (near base of right "b" pillar) g305
• (partial) (below steering column, on knee bolster)
• 12v
• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag
• Body control module (bcm) (below right side of dash)
• Case ground
• Data link connector (dlc)
• Driver seat
• Driver seat belt input
• Driver seat belt switch (open with driver seat belt buckled)
• Fuse block (right side of dash, in right front door opening)
• G305 (near base of right "b" pillar)
• Ground
• High control
• Hot in run, bulb test & start
• Ignition
• Inflatable restraint ip module
• Inflatable restraint sensing & diagnostic module (sdm) (below right front seat)
• Inflatable restraint steering wheel module
• Inflatable restraint steering wheel module coil
• Instrument panel cluster (ipc)
• Left front seat belt pretensioner
• Left inflatable restraint front side impact module (on left side of driver seat back cover)
• Left inflatable restraint side impact sensor (inside base of left "b" pillar, near seat belt retractor)
• Low control
• Nca
• Right front seat belt pretensioner
• Right inflatable restraint front side impact module (on right side of passenger seat back cover)
• Right inflatable restraint side impact sensor (inside base of right "b" pillar, near seat belt retractor)
• S304 (body harness, right front door approximately 28 cm (11 inches) from inflatable restraint sensing & diagnostic module breakout)
• Sdm fuse 15a
• Seat belt switch
• Serial data
• Shorting bar
• Signal
• Solid state
• Splice pack sp205 (below steering column, bottom of knee bolster)
• Tan
• Voltage