SUPPLEMENTAL RESTRAINTS – Chevrolet Venture LS 2005 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraints Wiring Diagram for Chevrolet Venture LS 2005

List of elements for Supplemental Restraints Wiring Diagram for Chevrolet Venture LS 2005:

• (at base of right "b" pillar) g302
• (right top of dash, above glove box) inflatable restraint ip module
• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag ind
• Body control module (bcm) (below right side of dash)
• Case ground
• Data link connector (dlc) (partial) (below steering column, on knee bolster)
• Driver seat assembly
• Driver seat belt input
• Driver seat belt switch (open with driver seat belt buckled)
• G302 (w/ value van) (at base of right "b" pillar)
• Ground
• High control
• Hot in run, bulb test & start
• I/p fuse block (right side of dash, in right front door opening)
• Ign
• Ignition
• Inflatable restraint sensing & diagnostic module (sdm) (below right front seat)
• Inflatable restraint steering wheel module (center of steering wheel)
• Inflatable restraint steering wheel module coil
• Instrument panel cluster (ipc)
• Left electronic frontal sensor (left front of vehicle)
• Left front seat belt pretensioner
• Left inflatable restraint side impact sensor (inside base of left "b" pillar, near seat belt retractor)
• Left side impact module (below driver's seat)
• Logic
• Low control
• Nca
• Pnk
• Right electronic frontal sensor (right front of vehicle)
• Right front seat belt pretensioner
• Right inflatable restraint side impact sensor (inside base of right "b" pillar, near seat belt retractor)
• Right side impact module (below right front seat)
• S304 (in body harness, near breakout for inflatable restraint sensing & diagnostic module)
• Sdm/sir fuse 15a
• Seat belt switch
• Serial data
• Shorting bar
• Signal
• Solid state
• Splice pack sp205
• Tan
• Voltage