SUPPLEMENTAL RESTRAINTS – Ford Expedition 2002 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Ford Expedition 2002

List of elements for Supplemental Restraint Wiring Diagram for Ford Expedition 2002:

• (lower left inner kick panel) g201
• (main harness, near breakout to connector c243 on central junction box) s2002
• (main harness, near breakout to ground g202, upper left inner kick panel) s208
• Air bag indicator
• Air bag indicator lamp
• Air bag sliding contact
• C2004
• C2005
• C238
• C239
• C242
• C243
• Central junction box (under left side of dash)
• Data link connector (dlc) (partial) (under center of dash)
• Diagnostic output
• Driver air bag
• Driver air bag feed
• Driver air bag return
• Driver preten feed
• Driver preten return
• Driver pretensioner
• Driver side air bag
• Driver side air bag crash sensor (near driver seat)
• Expedition w/ side air bags
• Expedition w/o side air bags
• Expedition w/o side air bags & navigator
• Expedition w/side air bags
• Fuse 22 10a
• Fuse 30 30a
• Generic electronic module (gem) (behind left side of dash)
• Ground
• Hot in run
• Hot in run or start
• Ignition
• Instrument cluster
• Left sab sensor feed
• Left sab sensor return
• Nca
• Pass air bag feed
• Pass air bag return
• Pass preten feed
• Pass preten return
• Passenger air bag
• Passenger pretensioner
• Passenger side air bag
• Passenger side air bag crash sensor (near passenger seat)
• Pin shorting bars engaged when module connector is disconnected from harness: (shorting bars are connected between following pins: 3-4, 6-7, 15-16, 18-22, 20 & 21 for conn c2005 2-3 & 5-6 for conn c2004
• Resistor a
• Resistor b
• Restraints control module (rcm) (behind right side of dash)
• Right sab sensor feed
• Right sab sensor return
• S229 (main harness, near breakout to conn c237 on instrument cluster)
• Sab feed
• Sab return
• Shorting bar
• Tone request
• Tone request input
• W/o side air bags
• W/side air bags