SUPPLEMENTAL RESTRAINTS – Ford Ranger 2002 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Ford Ranger 2002

List of elements for Supplemental Restraint Wiring Diagram for Ford Ranger 2002:

• (behind center dash panel) s205
• (behind center dash panel) s206
• (behind left side dash panel) g204
• (behind left side dash panel) s218
• (behind left side dash panel) s237
• (bottom of steering column) s209
• (left front side, vehicle floor) g205
• Air bag ind ctrl
• Air bag indicator
• Air bag sliding contact
• Air bag tone driver
• Battery
• Buckled
• C2100a
• C2100b
• C220c
• Central junction box (cjb) (behind left side of dash)
• Data link connector (dlc) (partial) (fastened to bottom of dash, near steering column)
• Dedicated ground
• Driver air bag feed
• Driver air bag return
• Driver air bag unit
• Driver safety belt feed
• Driver safety belt retractor pretensioner
• Driver safety belt rtn
• Fuse f2.11 7.5a
• Fuse f2.2 10a or 20a
• Fuse f2.26 10a
• Generic electronic module (gem) (behind center of dash)
• Hot at all times
• Hot in run
• Hot in run or start
• Ignition
• Instrument cluster
• Iso bus
• Nca
• Off
• Ohms
• Pad switch ind ctrl
• Pad switch input
• Pass air bag feed
• Pass air bag return
• Pass safety belt feed
• Pass safety belt rtn
• Passenger air bag deactivation (pad) switch
• Passenger air bag module
• Passenger safety belt retractor pretensioner
• Pin shorting bars engaged when module connector is disconnected from harness: (shorting bars are connected between following pins: 3-4, 6-7 & 20-21)
• Pretensioner
• Restraints control module (in center of vehicle, under dash)
• S208 (behind center dash panel)
• Safety belt sw input
• Shorting bar
• Un- buckled