SUPPLEMENTAL RESTRAINTS – Ford Taurus SES 2001 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Ford Taurus SES 2001

List of elements for Supplemental Restraint Wiring Diagram for Ford Taurus SES 2001:

• (driver side "a' pillar) g900
• (not used)
• (right rear side of engine compartment)
• Air bag indicator
• Air bag sliding contact
• C201c
• C220b
• C270b
• C270c
• C310a
• C310b
• Central junction box (under left side of dash)
• Data link connector (dlc) (partial) (mounted on dash, below steering column)
• Driver air bag module
• Feed
• Forward crash sensor (behind right side of front bumper)
• Fuse f223 10a
• Fuse f227 10a
• G900 (driver side "a" pillar)
• Generic electronic module (gem) (under left side of dash)
• Ground
• Hot in run or start
• Ignition
• Indicator
• Input
• Instrument cluster
• Iso bus
• Left safety belt assembly
• Left seat track position sensor
• Left side air bag module (in left front seat back)
• Left side air bag sensor
• Monitor
• Nca
• Other
• Passenger air bag module
• Pin shorting bars engaged when module connector is disconnected from harness. shorting bars are connected between following pins: 2-3, 5-6 & 9-10 c310a 3-4, 6-7, 11-12 & 20-21 c310b
• Red
• Restraints control module (under center of dash)
• Return
• Right safety belt assembly
• Right side air bag module (in right front seat back)
• Right side air bag sensor (under right front seat)
• S213 (under driver side, dash panel)
• S227
• Safety belt buckle pretensioner
• Safety belt buckle switch
• Sense
• Solid state
• Stage
• Stage 1
• Stage 2
• Tone driver
• W/o pwr seats