SUPPLEMENTAL RESTRAINTS
Supplemental Restraint Wiring Diagram for Lincoln Continental 2002
List of elements for Supplemental Restraint Wiring Diagram for Lincoln Continental 2002:
- (center left side of vehicle floor) s314
- (partial) (at bottom left of dash)
- Air bag indicator
- Air bag indicator driver
- Air bag sliding contact
- C2145a
- C220a
- C310a
- C310b
- C401b
- Central junction box (cjb) (below left side of dash)
- Control module
- Data link connector (dlc)
- Driver air bag feed
- Driver air bag return
- Driver air bag unit
- Fuse f2.5 10a
- Fuse f2.9 10a
- G200 (bottom of left "a" pillar)
- Ground
- Hot in run
- Hot in run or start
- Ignition
- Instrument cluster
- Iso bus
- Left side air bag feed
- Left side air bag module (w/side airbags) resistor a (w/o side airbags)
- Left side air bag return
- Left side air bag sensor (behind center bottom dash panel)
- Left side sensor feed
- Left side sensor return
- Lighting control module
- Lighting control module (lcm) (on left side of dash)
- Nca
- Pass air bag feed
- Pass air bag return
- Passenger air bag module
- Pin shorting bar is engaged when module connector is disconnected from harness (shorting bar is connected between pins: 3-4, 6-7, 20-21 conn. c310b 2-3 & 5-6 conn. c310a)
- Restraints
- Restraints control module (rcm) (between seats, below center console)
- Right side air bag feed
- Right side air bag module (w/side airbags) resistor b (w/o side airbags)
- Right side air bag return
- Right side air bag sensor (right side rocker panel)
- Right side sensor feed
- Right side sensor return
- S227 (under left side of dash panel)
- Shorting bar
- Vehicle emergency message system (vems) module (in right rear of trunk)
- Vems module
