SUPPLEMENTAL RESTRAINTS – Mercury Mountaineer 1999 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Mercury Mountaineer 1999

List of elements for Supplemental Restraint Wiring Diagram for Mercury Mountaineer 1999:

• (behind left side of dash)
• (engine compt harn, near breakout to left park/turn lamp) s131
• Air bag indicator
• Air bag sliding contact
• C2009
• C232
• C233
• C280
• C288
• C291
• Computer data lines system
• Data link (dlc)
• Data link connector (dlc)
• Driver air bag
• Driver air bag feed
• Driver air bag return
• Driver side air bag (w/ side airbags) resistor a (w/o side airbags)
• Driver side air bag crash sensor (left "b" pillar)
• Driver side air bag feed
• Driver side air bag return
• Driver side sensor feed
• Driver side sensor return
• Front crash sensor feed
• Fuse 15 7.5a
• Fuse 2 7.5a
• Fuse junction panel (below left side of dash)
• Fused ignition
• G108 (left radiator support)
• Generic electronic module (behind center of dash)
• Ground
• Hot in run
• Hot in run or start
• Indicator driver
• Instrument cluster
• Left primary crash sensor (left front of engine compt)
• Message center
• Nca
• Pass air bag feed
• Pass air bag return
• Pass side air bag feed
• Pass side air bag return
• Pass side sensor feed
• Pass side sensor return
• Passenger air bag
• Passenger side air bag (w/ side airbags) resistor b (w/o side airbags)
• Passenger side air bag crash sensor (right "b" pillar)
• Pin shorting bar is engaged when module connector is disconnected (shorting bar is connected between the following pins: 3-4, 6-7, 20-21)
• Restraints control module (behind right side of dash)
• Right primary crash sensor (right front of engine compt)
• S216 (dash harn, behind right side of dash)
• S217
• S232
• S255 (dash harn, center of dash)
• Shorting bar
• Tone generator