COMPUTER DATA LINES – Nissan Xterra PRO-4X 2011 – SYSTEM WIRING DIAGRAMS

COMPUTER DATA LINES

Computer Data Lines Wiring Diagram for Nissan Xterra PRO-4X 2011

List of elements for Computer Data Lines Wiring Diagram for Nissan Xterra PRO-4X 2011:

• (right rear of engine compt) engine control module (ecm)
• 48g
• A/t assembly (if equipped)
• Abs actuator & electric unit (control unit) (left rear corner of engine compt)
• Abs/tcs/vdc control unit
• Acc
• Air bag diagnosis sensor unit (under console box)
• Ant sig
• Audio unit
• Body control module (bcm) (under left side of dash)
• Can-h
• Can-l
• Combination meter
• Data link connector (under left side of dash)
• Diag-k
• Differential lock control unit (w/ electronic locking rear differential) (under center of dash)
• E122
• E152
• E16
• E26
• E57
• F14
• F32 e2
• F502
• Fuse 12 10a
• Fuse 19 10a
• Fuse 4 10a
• Fuse block (j/b) (right side of dash)
• Hot at all times
• Hot in on or acc
• Hot in on or start
• Ipdm e/r (right rear of engine compt)
• K-line
• M152
• M18
• M31
• M31 52g
• M35
• M41
• M42
• M91
• Nats antenna amplifier (behind center of dash)
• Pnk
• Rx, tx
• Rxd
• Satellite radio tuner (pre-wiring) (if equipped) (behind left side of dash)
• Steering angle sensor (below left side of dash, near steering column)
• Tcm (transmission control module)
• Transfer control unit (w/ 4-wheel drive) (behind left side of dash)
• Txd