CRUISE CONTROL – Chevrolet Tracker 2004 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Tracker 2004

List of elements for Cruise Control Wiring Diagram for Chevrolet Tracker 2004:

• (engine harness) s102
• (engine harness) s104
• A/t
• Brake signal
• Cancel
• Cancel signal
• Cruise control mode switch
• Cruise control release switch (above clutch pedal)
• Cruise control servo (left side of engine compartment, near strut tower)
• Cruise ind
• Engine controls system
• Fi fuse 15a
• Fuse block (on right side of engine compt in front of battery)
• G103 (right rear of engine compartment, mounted to intake manifold)
• G104 (left front of core support, near washer reservoir)
• G200 (behind left side of dash, above junction block)
• Ground
• Hot at all times
• Hot in start
• Ig fuse 20a
• Ignition
• Indicator control
• Instrument cluster
• Interior lights system
• Interrupt signal
• Junction block (in left kick panel)
• M/t
• Main cruise control switch
• Main relay (beside junction block)
• Main relay control
• Mode ground
• Mode signal
• O/d cut
• O/d cut signal
• Powertrain control module (pcm) (under right side of dash)
• Res/acc
• S103 (engine harness)
• S108
• S200
• S202
• S212 (main harness)
• S213 (main harness)
• S214 (main harness)
• S215 (main harness)
• S216 (main harness)
• S219
• S241
• S250
• Set/coast
• Sp200 (main harness)
• Speedo meter
• Starter solenoid
• Stop fuse 15a
• Stoplamp switch (above brake pedal)
• T/p signal
• Tp input
• Transmission range switch (on right side of transmission)
• Vehicle speed sensor (vss) (on right side of transmission)
• Vss input
• Wiper/washer switch