CRUISE CONTROL – Chevrolet Venture 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Venture 2005

List of elements for Cruise Control Wiring Diagram for Chevrolet Venture 2005:

• (in dash harness, near breakout for hazard lamp/turn signal flasher) s205
• A12
• A13
• A14
• A15
• All times
• Brake signal input
• C1 e5
• Cruise control module (ccm) (on left front strut tower)
• Cruise control on/off switch
• Cruise control release switch (mounted on top of brake pedal support)
• Cruise fuse 10a
• Cruise release
• Disable input
• Disable output
• Engaged input
• Engaged output
• G201 (at left side of dash)
• Ground
• Hot at
• Hot in run, bulb
• I/p fuse block (right side of dash, in right front door opening)
• Ignition
• Off
• On/off input
• Pnk
• Powertrain control module (pcm) (secured in air cleaner assembly, left front of engine compartment)
• R/a
• Resume/accel input
• S266
• Set sw
• Set/coast input
• Stop lamp fuse 15a
• Stoplamp switch (mounted on top of brake pedal support)
• Test or start
• Underhood junction box
• Vehicle speed input
• Vehicle speed sensor (vss) (mounted to right side of transaxle)
• Vss high
• Vss low
• Vss output