ANTI-LOCK BRAKES – Ford Ranger Splash 1997 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

All-Wheel ABS Wiring Diagram for Ford Ranger Splash 1997

List of elements for All-Wheel ABS Wiring Diagram for Ford Ranger Splash 1997:

• (4wabs) hydraulic unit (left side of engine compartment)
• (4wabs) indicator ctrl
• (4wabs) main relay (relay box #3: left rear of engine compt.)
• (4wabs) pmp rly coil (-) g-switch #2
• (4wabs) pump motor relay (relay box #3)
• (4wabs) relay coil (-)
• (dash to headlamp harn, in breakout to relay box 3) s129
• (left front of vehicle)
• 1400 ohms
• 4wabs diode
• 4wabs main relay maxi fuse 9 30a
• 4wabs pump motor
• 4wabs pump relay maxi fuse 10 30a
• Acceleration sensor (on inside of left frame rail)
• Anti-lock brakes indicator
• Brake on/off (boo) switch (on brake pedal support)
• Brake on/off sw feed
• C215
• C216
• Connector (dlc) (bottom of i/p, near steering column)
• Data link
• Diagnostic circuit
• Dump valve
• Engine compartment fuse/relay box (left rear of engine compt.)
• Four wheel anti- lock brake system (4wabs) control module (left front of engine compartment)
• Fuse 10a
• Fuse 15a
• Fuse 7.5a
• G-switch #1
• G-switch status
• G104 (top center of left fender apron)
• G108 (left side of upper radiator support)
• Ground
• Hot at all times
• Hot in run
• Hot in run or start
• I/p fuse panel (behind left side of i/p)
• Ignition (hot in run)
• Instrument cluster
• Iso
• Iso valve
• Left front
• Left front dump valve
• Left front iso valve
• Left front sensor (hi)
• Left front sensor (lo)
• Left front wheel speed sensor
• Motor speed sensor (hi)
• Nca
• Pnk
• Rear
• Rear axle sensor
• Rear dump valve
• Rear iso valve
• Rear sensor (high)
• Rear sensor (low)
• Red/pnk
• Right front
• Right front dump valve
• Right front iso valve
• Right front sensor (hi)
• Right front sensor (lo)
• Right front wheel speed sensor
• S118
• S124
• S125
• S132 (dash to headlamp harn, near breakout to starter relay)
• S142
• S148
• S225
• S240
• Tan
• Tan/red
• Valve
• Vehicle ref. voltage

Rear Wheel ABS Wiring Diagram for Ford Ranger Splash 1997

List of elements for Rear Wheel ABS Wiring Diagram for Ford Ranger Splash 1997:

• (main harn, near breakout to i/p fuse panel) s235
• (main harn, near breakout to i/p fuse panel) s236
• 1.2 ohms
• 22k ohms
• 4.0 ohms
• Abs ind
• Acc
• Boo switch input
• Brake fluid level sig
• Brake fluid level switch (left rear of engine compartment, on brake fluid reservoir)
• Brake ind
• Brake on/off (boo) switch (behind left side of i/p, on brake pedal support)
• C141
• C215
• C216
• Daytime running lamps (drl) module (left side of lower radiator support)
• Diag/keep alive input
• Diff speed sens (hi)
• Diff speed sens (lo)
• Dump sol output
• Engine compartment fuse/relay box (left rear of engine compt.)
• Fuse 11 7.5a
• Fuse 13 15a
• Fuse 14 20a
• Fuse 9 10a
• G104 (top center of left fender apron)
• G108 (left side of upper radiator support)
• Gnd
• Ground
• Hot at all times
• Hot in run
• Hot in run or start
• I/p fuse panel (behind left side of i/p)
• Ignition switch
• Instrument cluster
• Iso sol output
• Isolation solenoid
• Lock
• Nca
• Off
• Power input
• Rabs diode
• Rabs ind ctrl
• Rabs resistor
• Rabs test connector (c244) (behind right side of i/p)
• Rabs test connector (on rear of engine compartment fuse/relay box)
• Rear anti-lock brake system (rabs) module (behind lower center of i/p, left side of ashtray assembly)
• Rear anti-lock brake system (rabs) proportioning valve switch assembly (below left side of vehicle, on inside of left frame rail)
• Rear axle sensor (top of rear differential)
• Red
• Red/pnk
• Run
• S118
• S120 (dash to headlamp harn, left side of safety wall)
• S131
• S150 (dash to headlamp harn, in breakout to engine cpmpt fuse/relay box)
• S204
• S205
• S228
• S240
• S244
• Start
• Valve reset input
• Valve reset switch