CRUISE CONTROL – Chevrolet Equinox LS 2006 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Equinox LS 2006

List of elements for Cruise Control Wiring Diagram for Chevrolet Equinox LS 2006:

• brake/cruise release sw sig
• (in body harness, near cross car breakout) s304
• (in center of steering wheel, under module) inflatable restraint steering wheel module coil
• 5 volt ref 1
• 5 volt ref 2
• A pnk
• A12
• Accelerator pedal position (app) sensor (on accelerator pedal linkage arm)
• All times
• App sens 1 sig
• App sens 2 sig
• App sensor 1
• App sensor 2
• Brake fuse 15a
• C276
• C277
• Chevrolet
• Computer data lines system
• Cruise fuse 2a
• Cruise/ brake switch (on brake pedal bracket)
• E7 c2
• G201 (behind right front kick panel)
• Hot at
• Hot in run or start
• I/p fuse block (behind center of dash, beneath right side of radio)
• Left steering wheel control switch
• Low ref
• On/off ind
• Oss high sig
• Oss low sig
• Output speed sensor (oss) (at top of automatic transmission, below brake master cylinder)
• Pnk
• Pontiac
• Powertrain control module (pcm) (in engine compartment, mounted on top of battery cover)
• Res+
• Right steering wheel control switch
• S209
• S211
• Serial data bus+
• Serial data bus-
• Set-
• Stop lamp sw sig
• Stop lamp switch (on brake pedal bracket)
• Stop lamp switch sig
• Sw sig
• Tan
• Throttle actuator control (tac) module (attached to throttle body)
• Transmission control module (tcm) (at left side of engine compt)
• Uart serial data 1
• Uart serial data 2
• Underhood fuse block (left side of engine compt)
• Underhood fuse block (left side of engine compt)
• W/ accessory steering wheel
• W/o accessory steering wheel