CRUISE CONTROL – Toyota RAV4 1997 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Toyota RAV4 1997

List of elements for Cruise Control Wiring Diagram for Toyota RAV4 1997:

• (2wd)
• (4wd)
• (a/t)
• (i/p harn, right side of dash)
• (i/p harness, front of center console)
• (i/p harness, under right side of dash)
• (left kick panel) g200
• (m/t)
• (right side, middle of engine compartment) data link connector 1
• (under center of dash)
• B10
• B18
• Batt
• Cancel
• Ccs
• Cms
• Cruise control actuator (rear left corner of engine compartment)
• Cruise control clutch switch (m/t only) (on bracket, above clutch pedal)
• Cruise control ecu (behind right side of dash)
• Cruise control switch (combination switch)
• Cruise cruise cruise control control control ind ind ind
• Dome fuse 15a
• Ect
• Ecu-ig fuse 7.5a
• Engine control module (below ctr of dash)
• Engine controls system (throttle position sensor)
• Fuse block (lower left side of dash)
• G203 (right kick panel)
• Gauge fuse 10a
• Gnd
• Hot at all times
• Hot in on and acc
• I11
• Idl
• Instrument cluster
• J/b 1 (lower left side of dash)
• J/b 3 (under center of dash)
• J/c 6
• J/c 7 (center of dash)
• Main
• Od1
• Park/neutral position switch (a/t only) (front of transaxle)
• Pnk
• Relay block 2 (left shock tower)
• Resume/ accel
• Set/ coast
• Spd
• Stop fuse 10a
• Stop light switch (under left side of dash, at brake pedal bracket)
• Stp-
• Transmissions system (electronically controlled transmission solenoid)
• Vehicle speed sensor (on transmission)
• Vr1
• Vr2
• Vr3
• Vss output