TRANSMISSION – Buick LeSabre Custom 1994 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

Transmission Wiring Diagram, 4T60-E for Buick LeSabre Custom 1994

List of elements for Transmission Wiring Diagram, 4T60-E for Buick LeSabre Custom 1994:

• (left side of engine
• (right front
• (right front of engine under electronic ignition module)
• 5 volt ref
• A13
• B11
• B12
• B13
• B14
• Battery
• Brake switch (behind left side of i/p, on brake pedal support)
• C109
• C12
• C126
• C3
• Coolant temp sensor (top left side of engine behind throttle body)
• Cruise control system
• Cruise on input
• Cts
• Data line input/output
• Data link conn (partial) (under left side i/p)
• Diag request input
• E12
• E14
• E15
• Engine control system
• F11
• F13
• F14
• Fuse #4 20a
• Fuse #5c 10a
• Fuse #8 10a
• G119
• Ground
• Hot at all times
• Hot in run
• Hot in run, bulb test or start
• I/p fuse block
• Ign feed
• Intake air temperature sensor
• Nca
• Of engine
• On transaxle)
• Park/neutral
• Pnk
• Position switch
• Powertrain control module (pcm) (behind right dash panel, at cowl)
• Red
• Relay center (behind right side of i/p, top of right shroud)
• Rh underhood fuse block (center rear of engine compartment)
• Sensor ground
• Shift a sol ctrl
• Shift a solenoid
• Shift b sol ctrl
• Shift b solenoid
• Tan
• Tcc brake input
• Tcc pwm sol ctrl
• Tcc pwm solenoid
• Tcc sol ctrl
• Tcc solenoid
• Throttle position sensor (top left side of engine, under mass air flow sensor)
• Tps
• Trans position sw
• Trans position sw a
• Trans position sw b
• Trans position sw in
• Trans temp in
• Trans temp sensor
• Transaxle
• Under electronic ignition module)
• Vehicle speed sensor (lower rh rear of engine, left of oil filter)
• Vss in-hi
• Vss in-lo