TRANSMISSION
Transmission Wiring Diagram, 4T60-E for Chevrolet Beretta Z26 1994
List of elements for Transmission Wiring Diagram, 4T60-E for Chevrolet Beretta Z26 1994:
- (20 ga-rust)
- (center rear of engine, on transaxle stud)
- (left lower hush panel)
- (partial)
- 5v ref
- A/c on in
- A/c sensor
- Automatic transaxle
- Battery ref
- Brake switch (on brake pedal support)
- Brake transaxle shift interlock solenoid
- Clutch
- Conn c1
- Conn c2
- Conn c3
- Data link connector
- Ects in
- Engine coolant temperature (upper right rear of engine, near exhaust system)
- Fuse 1 15a
- Fuse 5 20a
- Fuse 9 20a
- Fuse block
- Fusible link
- G115
- Gnd
- Heater and a/c control assembly
- Hot at all times
- Hot in run, bulb test or start
- Ign
- Instrument cluster
- Malfunction indicator lamp
- Map sensor
- Mil ctrl
- Multi- function alarm module
- Nca
- P/n in
- P/n sig out
- Park/neutral position switch (left rear of engine, right top of transaxle)
- Pnk
- Pnp switch a in
- Pnp switch b in
- Pnp switch c in
- Pnp switch parity in
- Powertrain control module (pcm) (right upper i/p, attached to bracket)
- Red
- Sensor
- Sensor gnd
- Serial data in/out
- Shift a solenoid
- Shift b solenoid
- Shift sol a ctrl
- Shift sol b ctrl
- Tan
- Tcc ctrl
- Tcc pwm sol ctrl
- Tcc pwm solenoid
- Temp.
- Throttle position position (rear of engine, right side of throttle body)
- Tps in
- Trans fluid temp sensor in
- Transaxle
- Transaxle converter
- Vehicle speed sensor (lower right front of engine, on right transaxle output shaft housing)
- Vss in-hi
- Vss in-lo
- With a/c