TRANSMISSION – Chevrolet Corvette Z06 2008 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

Transmission Wiring Diagram for Chevrolet Corvette Z06 2008

List of elements for Transmission Wiring Diagram for Chevrolet Corvette Z06 2008:

• Accessory volt
• Accy volt sig
• Automatic transmission
• Automatic transmission input shaft spped (iss) sensor
• Automatic transmission internal mode switch (ims)
• Battery
• Battery pos volt
• Battery positive volt
• Body control module (mounted on toe board, in right footwell)
• Cluster/ hud fuse 15a
• Computer data lines system
• Cruise switch fuse 2a
• D10
• D11
• Data
• Data bus +
• Data bus -
• Driver information center (dic)
• Ecm/tcm/ easy key fuse 11 15a
• Engine control module (ecm) (behind right front fender, between wheelhouse & dash panel)
• Engine controls system
• F11
• G106 (on right rear side of engine, above starter solenoid)
• G201 (at base of left "a" pillar)
• Ground
• Hot at all times
• Hot in on or start
• Ignition 1
• In speed sensor sig
• Inflatable restraint steering wheel module coil (center of steering column)
• Instrument panel cluster
• Iss signal
• J106
• J303
• Left automatic transmission manual shift switch
• Logic
• Navigation & sound systems
• Nca
• Oss signal
• Out speed sensor sig
• Park/neutral sig
• Pnk
• Power distribution system
• Range signal a
• Range signal b
• Range signal c
• Range signal p
• Red
• Right automatic transmission manual shift switch
• Selector sig
• Serial data bus +
• Serial data bus -
• Stop lamp sig
• Stop lamp sw sig
• Tan
• Tcm/trans fuse 1 10a
• Transmission control module (tcm)
• Underhood fuse block (on right side of engine compt)
• X276
• X277