TRANSMISSION – Chrysler Concorde LXi 1997 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

Transmission Wiring Diagram (1 of 3) for Chrysler Concorde LXi 1997

List of elements for Transmission Wiring Diagram (1 of 3) for Chrysler Concorde LXi 1997:

• (eng harn, in headlamp breakout)
• (eng harn, near trans solenoid breakout)
• 2-4 press sw
• 2-4 pressure switch
• 2-4 sol ctrl
• 2-4 solenoid
• A14
• A41
• Auto stick dn sw
• Ccd bus (+)
• D21
• F11
• Front frame rail)
• Fuse 17 5a
• Fused (b+)
• Fused ign out
• G113 (side of left
• Gnd
• Hot in off, run or start
• Input (turbine) speed sensor (on left side of trans- mission)
• Input spd sns sig
• Junction block
• K22
• K24
• Low/ reverse pressure switch
• Low/ reverse solenoid
• Low/rev press
• Low/rev sol. ctrl
• Od solenoid ctrl
• Output spd sns
• Over- drive solenoid
• Overdrive pressure switch
• Pnk
• Pnp sw sense
• Red
• S117
• S147
• Sci receive
• Sci transmit
• Sensor gnd
• Spd sensor gnd
• T10
• T13
• T14
• T15
• T16
• T19
• T20
• T41
• T42
• T44
• T47
• T50
• T52
• T54
• T59
• T60
• Torq mgmt req
• Tps sig
• Tr rng t42 sens
• Trans rly out
• Trans temp sig
• Transmission control module (in left front corner of eng compt)
• Transmission output shaft speed sensor (on left side of transmission)
• Transmission solenoid & pressure switch assembly (transmission)
• Ud solenoid ctrl
• Under- drive solenoid
• Vss sig
• Z13
• Z14

Transmission Wiring Diagram (2 of 3) for Chrysler Concorde LXi 1997

List of elements for Transmission Wiring Diagram (2 of 3) for Chrysler Concorde LXi 1997:

• Acc
• Automatic shutdown relay
• Autostick switch (intrepid & vision only) (integral with gearshift mechanism)
• Back-up lamp switch
• Engine starter motor relay, fuel pump relay
• Exterior lights system (back-up lamps)
• Fuse a 20a
• Fuse b 20a
• G113 (side of left front frame rail)
• G200 (left kick panel)
• Hall effect switches
• Hot at all times
• Ignition switch
• Junction block
• Lock
• Nol
• Off
• P3l
• Pnk
• Power distribution center
• Prnl
• Red
• Run
• S107
• S110
• S113
• S116
• S304
• Start
• Trans sensor
• Transmission range switch (in transmission, on top of valve body)
• Transmission relay

Transmission Wiring Diagram (3 of 3) for Chrysler Concorde LXi 1997

List of elements for Transmission Wiring Diagram (3 of 3) for Chrysler Concorde LXi 1997:

• (eng harn, near ambient temp sensor breakout)
• (eng harn, near drl or drl jumper breakout)
• (eng harn, near eng to hl/lp & dash connector)
• (eng harn, near left headlamp breakout)
• (eng harn, near right headlamp breakout) s135
• (side of right front frame rail)
• A14
• Air conditioning system & powertrain control module
• Ccd bus (+)
• Ccd bus (-)
• Ckp sensor sig
• Computer data lines system
• Crankshaft position sensor
• D21
• Data link connector (on left of
• Ect sensor sig
• Engine controls system
• Engine coolant temperature sensor (front of intake)
• Engine starter motor relay (in power distribution center)
• F12
• Fuel pump relay, controller anti-lock brake
• Fuse 10a
• Fuse 15a
• Fused b (+)
• G118
• G302 (right side of acm bracket)
• Gnd
• Hot in run
• Hot in run & start
• Ign (run/start)
• Junction block
• K22
• K24
• K29
• P/n sw sense
• Pnk
• Powertrain control module (in right front corner of eng compt)
• S114
• S120
• S122
• S123
• S128
• S133
• S134 (in right heahdlamp breakout)
• S137
• S138
• S139
• S141 (eng harn, near right side fuel inj breakout)
• S154
• S222
• Sci transmit
• Sensor gnd
• Speed proportional steering module
• Speed proportional steering module, controller anti- lock brake, daytime running lamp module
• Steering column)
• Stop lamp switch (top of brake pedal)
• Stop lp sw sense
• T10
• T41
• Throttle position sensor (on throttle body)
• Torque req sense
• Tp sens sig
• Vss signal
• W/ speed proportional steering
• W/o speed proportional steering
• Z12