TRANSMISSION
Transmission Wiring Diagram for Honda Prelude S 1996
List of elements for Transmission Wiring Diagram for Honda Prelude S 1996:
- (behind center console)
- (right front of engine compt) shift control solenoid valves
- (right side
- A/t gear position ind
- A/t gear position switch (below left side of front console)
- Atp1
- Atp2
- Atpd3
- Atpd4
- Atpnp
- Atpr
- Backup lights
- Bksw
- Brake switch (top of brake pedal support)
- C18
- C409
- C424
- C469
- C601
- Counter-shaft speed sensor (rear of transmission)
- Cruise control system
- D10
- D11
- D12
- D4ind
- Dimming circuit
- Ect
- Engine coolant temperature sensor (right side of engine)
- Exterior lights system
- Fuse 13 10a
- Fuse 14 7.5a
- Fuse 41 15a
- G120 (right side of engine)
- G201
- G206 (behind left side of front console)
- Ground
- Hot at all times
- Hot in on or start
- Ignition
- Ilu
- Interior lights system
- Interlock control unit
- Junction connector (left side of dash)
- Lca
- Lcb
- Lock-up control solenoid valves (right front of engine compt)
- Main gauge assembly
- Main-shaft speed sensor (front of transmission)
- Nca
- Nmsg
- Of dash)
- Powertrain control module (front passengers foot rest)
- Ref
- Scs
- Service check connector
- Sg1
- Sg2
- Sha
- Shb
- Throttle position sensor (center rear of engine)
- Tps
- Under- dash fuse/ relay box
- Under- hood fuse/ relay box
- Under-dash fuse/relay box
- Vcc2
- Vehicle speed sensor (on trans- mission)
- Vss
- Vss out