TRANSMISSION – Jaguar XJ8 L 1998 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

A/T Wiring Diagram for Jaguar XJ8 L 1998

List of elements for A/T Wiring Diagram for Jaguar XJ8 L 1998:

• (center of dash, on firewall) g206
• 10-11
• 19-20
• 24-25
• 38-41
• 46-50
• 56-81
• 87-88
• Battery
• Ca1
• Can data +
• Can data -
• Computer data lines system
• D-4 switch
• D-4 switch (center console assembly)
• Em19
• Em20
• Engine compartment fuse box (left front of eng compt)
• Engine control module (engine compartment, control module enclosure) em10
• Engine management fuse box (left side of eng compt)
• Fluid temp sens
• Fluid temp sensor
• Fuse 10a
• Fuse 5a
• G100 (front of left front fender)
• G302 (left side of transmission tunnel)
• Gear selector module (front of gear selector assembly)
• Ground
• Hot at all times
• Hot in run or start
• Ignition
• Interior lights system
• Kickdown switch
• Kickdown switch (below accelerator pedal)
• Kickdown switch and circuit are for early production models
• Left heelboard fuse box (on left side of heelboard)
• Lsb
• Mode switch
• Nca
• Note: early production vehicles with vin numbers below (vin 003300) use connector pin numbers, which differ from volume production models shown. use wire color code for pin identification on early production models.
• Ouput spd sen
• Output spd sen
• Output speed sensor
• P, n sig
• P,n
• Press reg 1
• Press reg 2
• Press reg 3
• Press reg 4
• Press reg 5
• Press reg comm
• Red
• Red/pnk
• Regulaltor valves
• Rot sw l1
• Rot sw l2
• Rot sw l3
• Rot sw l4
• Shield
• Shield wires on tcm, pins 23 and 15, are reversed on early production models
• Sol vlv 1
• Sol vlv 2
• Sol vlv 3
• Sol vlvs comm
• Solenoid valves
• Sprt mode sw
• Sw common grd
• Transmission
• Transmission control module (in eng compt control module enclosure)
• Transmission rotary switch
• Turbine spd sen
• Turbine speed sensor