TRANSMISSION
A/T Wiring Diagram for Mitsubishi Diamante 1999
List of elements for A/T Wiring Diagram for Mitsubishi Diamante 1999:
- (under left side of center console) mfi relay i
- (under left side of dash)
- (under right side of dash) a/t control relay
- A/t control solenoid valve assembly (in transaxle)
- A/t oil temp
- Accelerator pedal position sensor (on throttle body)
- Anti-lock brake system (w/ traction control system)
- Assist ecu (under right side of dash, near kick panel)
- B-76
- B109
- B110
- B111
- B78
- B84 junction block (behind left side of dash)
- Data link connector
- Dedicated fuse 13 15a
- Dedicated fuse 9 20a
- Engine a/t ecu (under center of dash, forward of center console)
- Engine compartment relay box (left front fender)
- Engine coolant temperature sensor (left side of eng compt)
- Exterior lights system
- Flash memory connector (under left side of dash)
- G123 (right side of firewall)
- G302 (under center console)
- Hot at all times
- Hot in run or start
- Idle sw
- Input shaft speed sensor (on transaxle)
- Junction block (behind left side of dash)
- Low/ reverse
- Multi- purpose fuse 3 15a
- Multi- purpose fuse 5 10a
- Ouput shaft speed sensor (on transaxle)
- Over drive
- Park/neutral position switch (left front of engine compt)
- Red
- Second
- Starting/ charging
- Stop- light switch (above brake pedal)
- Throttle position sensor (on throttle body)
- Torque converter control
- Under drive
- Vehicle speed sensor (left front of eng compt)
- W/ tcl
- W/o tcl