TRANSMISSION – Mitsubishi Outlander XLS 2005 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

Transmission Wiring Diagram for Mitsubishi Outlander XLS 2005

List of elements for Transmission Wiring Diagram for Mitsubishi Outlander XLS 2005:

• (behind lower right side of dash)
• A/t control relay (on engine compartment relay box)
• A/t control solenoid valve assembly (on rear of transaxle)
• A/t fluid temp sensor
• A/t temp ind
• Auto
• C-04
• C-05
• C-103
• C-109
• C-110
• C-111
• C-112
• C-202
• C-205
• C22 data link connector (below left side of dash)
• C23
• Combination meter
• Engine compartment relay box (on left side of engine compt)
• Engine controls system
• Exterior lights system
• Fuse 15a
• Fuse 20a
• Fuse 7.5a
• G6 (behind left side of dash)
• Hot at all times
• Hot in run or start
• Input shaft speed sensor (on top center of transaxle)
• J/c 1 (behind right side of dash, taped to harness)
• J/c 2 (behind right side of dash, taped to harness) red
• J/c 3 (behind left end of dash)
• Junction block (behind left end of dash)
• Low/ rev
• Mfi relay (on engine compartment relay box)
• Output shaft speed sensor (on top right of transaxle)
• Over drive
• Powertrain control module (behind glove box)
• Red
• Second
• Shift ind
• Shift switch assembly (at gear selector assembly)
• Sport
• Stop light switch (above brake pedal, on bracket)
• Tac motor
• Throt- tle actu- ator control motor relay (on engine compt relay box)
• Throttle position sensor (on throttle body)
• Torque converter clutch control
• Transmission range switch (at left front of engine compt)
• Under drive