TRANSMISSION – Nissan 300ZX 2+2 1995 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

Transmission Wiring Diagram for Nissan 300ZX 2+2 1995

List of elements for Transmission Wiring Diagram for Nissan 300ZX 2+2 1995:

• (not used)
• A/t check ind.
• A/t control unit (on passenger floor board, under carpet)
• A/t fluid temp. sensor
• Ascd control unit (behind center console)
• Atck
• Automatic trans- mission red
• Avcc
• Backup lights
• Closed throttle
• Cruise
• Data link connector (for consult) (below left side of i/p)
• Dropping resistor (right rear of engine compt)
• Dt1
• Dt2
• Dt3
• Eccs control module (behind center console)
• Fuse 10a
• Fuse 20a
• Fuse block (left kick panel)
• G101 (right front fender)
• G112 (left side of engine)
• G200 (left kick panel)
• Gnd-a
• Gnd-c
• Hot at all times
• Hot in on or start
• Idle
• Ind.
• Inhibitor switch (right side of trans- mission)
• Instrument cluster
• Kickdown switch (on bracket, above accelerator pedal)
• Line press. sol. valve
• Nca
• Neut
• O.d. off ind.
• O/d clutch sol. valve
• Over- drive switch
• Pnk
• Red
• Relay box (forward of left front shock tower)
• Revolution sensor (left transmission)
• Shift sol. valve a
• Shift sol. valve b
• Speedometer
• Stop lamp switch (top of brake pedal)
• Tacho
• Tachometer
• Tcc sol. valve
• Throttle position sensor (on throttle body)
• Throttle position switch (on throttle body)
• Tvo
• Tvoo
• Vb-r
• Vehicle speed sensor
• Vsp
• Warning lamps
• Wot