TRANSMISSION – Suzuki Equator 2011 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

4WD Wiring Diagram (1 of 2) for Suzuki Equator 2011

List of elements for 4WD Wiring Diagram (1 of 2) for Suzuki Equator 2011:

• 13g
• 14g
• 15g
• 16g
• 17g
• 18g
• 20g
• 21g
• 22g
• 23g
• 24g
• 25g
• 2wd ind
• 2wd sw
• 4h sw
• 4hi ind
• 4l pos sw
• 4l sw
• 4lo ind
• 4lo switch
• 4wd fail
• 4wd ind
• 4wd pos sw
• 71g
• 72g
• Acc
• Actr sw1
• Actr sw2
• Actr sw3
• Actr sw4
• Atp ind
• Atp sw
• Atp switch
• Can-h
• Can-l
• Combination meter
• Computer data lines
• Computer data lines system
• E10
• E15 (engine compt)
• E152
• E19
• E24 (engine compt)
• F14
• F33
• Fuse 10a
• Fuse block (j/b) (under right side of dash)
• Gnd
• Gnd neut sw (w/ mt)
• Hot at all times
• Hot in on or start
• Ign sw
• Ignition switch
• K-line
• M152
• M153
• M31
• M31 19g
• M57 (above steering column)
• M61 (on right side of dash frame)
• M61 (right side of dash frame)
• Mem b/u
• Mtr +
• Mtr -
• Mtr mon1
• Mtr mon2
• Mtr rly 1
• Mtr rly 2
• Off
• Park neutral position (pnp) switch (m/t)
• Pnk
• Red
• Ssof
• Start
• System
• Transfer control unit (left side of dash)
• Unified meter control unit (w/ information display)
• Vign
• Wait detection switch

4WD Wiring Diagram (2 of 2) for Suzuki Equator 2011

List of elements for 4WD Wiring Diagram (2 of 2) for Suzuki Equator 2011:

• (fuse & relay box) transfer shift high relay
• (left rear engine compt)
• 12g
• 2wd
• 4lo
• 4wd shift switch
• Actr sw 1
• Actr sw 2
• Actr sw 3
• Actr sw 4
• E152
• E24 (engine compt)
• F32
• Fuse & fusible link box (left rear engine compt)
• Fuse & relay box
• Fuse 10a
• Fuse link j 40a
• Hot at all times
• Interior lights system
• M31
• Red
• Transfer control device (actuator position switch)
• Transfer shift low relay (fuse & relay box)
• Transfer shut off relay 1 (fuse & relay box)
• Transfer shut off relay 2 (fuse & relay box)

A/T Wiring Diagram for Suzuki Equator 2011

List of elements for A/T Wiring Diagram for Suzuki Equator 2011:

• (2.5l: engine compt) (4.0l: radiator support) f10
• (w/ information display)
• 1st position switch
• 45g
• 76g m31
• A/t assembly
• A/t fluid temperature sensor 1
• A/t oil temp ind
• A/t shift selector
• Atf pressure switch 2 (lc/b)
• Atf sens1+
• Atf sens1-
• C1 (vin)
• C2 (vout)
• C3 (gnd)
• Can-h
• Can-l
• Combination meter
• Computer data lines system
• Direct clutch solenoid valve
• E119
• E152
• Exterior lights system
• F10 (2.5l: engine compt) (4.0l: radiator support)
• F14
• F502
• F503
• F504
• F505
• F506
• Fuse 10a
• Fuse block (j/b) (under right side of dash)
• Gnd
• Hot at all times
• Hot in on or start
• Input clutch solenoid valve
• Input speed sensor 1
• Input speed sensor 2
• Ipdm e/r (left rear engine compt)
• K-line
• Line pressure solenoid valve
• M31
• M57 (above steering column)
• M61 (on right side of dash frame)
• O/d off ind
• Out spd
• Out spd gnd
• Out spd sens
• Output speed sensor
• Over-drive control switch
• Pnk
• Power gnd-1
• Power gnd-2
• Red
• Rev rly
• Sens pwr
• Start rly
• Starting/charging system
• Tcm (transmission control module)
• Torque converter clutch solenoid valve
• Tr sw1
• Tr sw2
• Tr sw3
• Tr sw4
• Transmission range switch
• Unified meter control unit
• V ign
• V out
• Vcc

Differential Lock Wiring Diagram for Suzuki Equator 2011

List of elements for Differential Lock Wiring Diagram for Suzuki Equator 2011:

• 13p
• 23c
• 24c
• 35g
• 36g
• C115
• C14
• Can h
• Can l
• Combination meter
• Computer data lines system
• Diff lock cu
• Diff lock cu (backup)
• Diff lock high
• Diff lock ind
• Diff lock low
• Diff lock sw
• Diff lock sw off
• Diff lock sw on
• Differential lock control unit
• Differential lock mode switch
• Differential lock position switch
• Differential lock solenoid
• E152
• E24 (engine compt)
• E41
• Fuse 10a
• Fuse block (j/b) (under right side of dash)
• Gnd
• Hot at all times
• Hot in on or start
• M31
• M4 5p
• Pnk
• Sss