WARNING SYSTEMS – Buick Park Avenue Ultra 2005 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Warning Systems Wiring Diagram for Buick Park Avenue Ultra 2005

List of elements for Warning Systems Wiring Diagram for Buick Park Avenue Ultra 2005:

• (right kick panel) g201
• A12
• A7 c3
• Ajar
• B11
• B12
• Battery positive voltage
• Body control module (bcm) (behind glove box)
• C10
• C12
• C2 c3
• C3 c4
• Check tire pressures
• Chime
• Chime ctrl
• Class 2 serial data
• Computer data lines system
• Crank voltage
• Crk fuse 5a
• Cstr/sbm fuse 10a
• D14
• Dome
• Door ajar
• Door open
• Driver door lock actuator (rear of right front door)
• Driver door module (inside driver's door, above radio speaker)
• Driver information center (dic)
• Driver seat belt switch signal
• E5 c3
• F11
• F5 c3
• Fasten seat belt ind
• G202 (left kick panel)
• Ground
• Headlamps off signal
• Hot at all times
• Hot in run or start
• Hot in start
• Hot in start, run & unlock
• I/p fuse block (behind glove box)
• Ignition 1 voltage
• Ignition key alarm switch (closed w/ key in ignition switch) (in steering column)
• Instrument panel cluster (ipc)
• Key in ign
• Lamp control module (behind left side of dash, right of steering column)
• Left front seat belt switch
• Left underhood fuse block (on right front of engine compt, near battery)
• Lights on ctrl
• Logic
• Low reference
• Nca
• Pnk
• Power distribution system
• Rear fuse block (below right side of rear seat)
• Remote control door lock receiver (under center of rear package shelf)
• Return
• S213
• S298
• S332
• Sbm fuse 10a
• Sbm lcm fuse 10a
• Seat belt indicator ctrl
• Tan
• Unlock/run/crank voltage