WARNING SYSTEMS
Warning Systems Wiring Diagram for Cadillac SRX 2008
List of elements for Warning Systems Wiring Diagram for Cadillac SRX 2008:
- (or tan)
- (under center console) inflatable restraint sensing & diagnostic module (sdm)
- (w/ theft deterrent system)
- (w/o theft deterrent system)
- Acc
- Air bag fuse 10a
- Auto
- Body control module (on lower left side of dash)
- Brake fluid level switch (on master brake cylinder reservoir)
- Brake fluid warning signal
- Brake ind
- Computer data lines system
- Driver door control module (inside driver door panel)
- Driver door latch assembly (rear of driver's door)
- Driver seat belt switch
- G101 (at left rear of engine compt, on the frame)
- G200 (behind left kick panel)
- Head
- Headlamps on sig
- Hot at all times
- Hot w/ ign relay energized
- Ign sw fuse 2a
- Ignition 0 sig
- Ignition key alarm switch
- Ignition switch
- Inflatable restraint i/p module indicator
- Instrument panel cluster (ipc)
- J201
- J203
- J205
- J209
- J305 (in body harness, 12 cm from g306)
- J501
- Left front door open sw sig
- Left seat belt sw sig
- Lo spd gmlan serial data
- Logic
- Low ref
- Low speed gmlan serial data
- Off
- Park
- Park brake sw sig
- Park brake switch (under left side of dash, on park brake pedal assy)
- Park lamps sply volt
- Passenger seat belt ind
- Passenger seat belt ind ctrl
- Passenger seat belt switch
- Pnk
- Power distribution system
- Radio
- Red
- Right seat belt sw sig
- Run
- Seat belt ind
- Start
- Tire pressure ind
- Turn signal/ multi-function switch
- Underhood fuse block (at right front of engine compt)