WARNING SYSTEMS
Warning Systems Wiring Diagram for Chevrolet Caprice PPV 2011
List of elements for Warning Systems Wiring Diagram for Chevrolet Caprice PPV 2011:
- (base of park brake handle) park brake switch
- (master cylinder reservoir) brake fluid level switch
- Acc
- Auto
- Battery positive volt
- Body control module (bcm) (above accelerator pedal)
- Brake ind
- Brake warning ind ctrl
- Computer data lines system
- Dlis/ theft dtrnt fuse 2a
- Door ajar ind
- Driver door latch assembly
- Driver information center (dic) display
- Driver seat belt sw
- Driver seat belt switch (driver's seat belt buckle assembly)
- Drv door ajar sw sig
- G102 (right side of engine compt)
- G201 (right end of dash)
- G304 (right kick panel)
- G305 (left kick panel)
- Gmlan ser data bus+
- Gmlan ser data bus-
- Gnd
- Head
- Headlamp switch
- Hot at all times
- Ign key resistor low ref x1
- Ignition switch
- Inflatable restraint sensing & diagnostic module (sdm) (center console)
- Instrument cluster
- Instrument panel fuse block (left side of dash)
- J220
- J312 (body harness, under driver seat approximately 5 cm from connector x315)
- J318 (body harness, base of left "a" pillar)
- J510
- J610
- Key-in switch
- Left rear door latch assembly
- Logic
- Low ref
- Low spd gmlan ser data
- Low spd gmlan serial data
- Off
- Park
- Park brake sw sig
- Park lamp sw on sig
- Pass door ajar sw sig
- Passenger door latch assembly
- Passenger seat belt sw
- Passenger seat belt switch (passenger's seat belt assembly)
- Radio
- Rear body fuse block (left luggage compt, above battery)
- Right rear door latch assembly
- Run
- Rvc snsr fuse 7.5a
- Seat belt ind
- Serial data
- Start
- X104
- X202
- X261
- X262
- X310
- X311
- X370
- X403
- X500
- X600
- X700
- X800