WARNING SYSTEMS – Chevrolet Corvette Z06 2008 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Warning Systems Wiring Diagram for Chevrolet Corvette Z06 2008

List of elements for Warning Systems Wiring Diagram for Chevrolet Corvette Z06 2008:

• (i/p harness, 8 cm from data link connector breakout) pnk j221
• Ajar
• Auto
• Body control module (bcm) (mounted on toe board, in right footwell)
• Brake fluid level switch (in master cylinder reservoir)
• Brake ind
• Brk fluid lvl sens sig
• Class 2 (sdm)
• Class 2 serial data
• Closed
• Computer data lines system
• Driver door latch (in rear of driver door)
• Driver information center (dic)
• Driver seat belt switch (in driver's seat belt buckle assembly)
• Ecm high spd gmlan serial data bus +
• Ecm high spd gmlan serial data bus -
• Engine control module (ecm) (behind right front fender, between wheelhouse & dash panel)
• G101 (on left frame rail)
• G201 (at base of left "a" pillar)
• G301 (at left "b" pillar, behind trim panel)
• Gmlan (ebcm)
• Head
• High spd gmlan serial data bus +
• High spd gmlan serial data bus -
• Ign
• Inflatable restraint sensing & diagnostic module (sdm) (below center of dash, under hvac control head)
• Instrument panel cluster (ipc)
• Internal antenna
• Ipc
• Ipc class 2 serial data
• J101
• J275
• J301
• J391 (driver seat harness, 10 cm from pnk seat belt switch) b
• Left
• Left seat belt sw
• Left turn ind
• Lf dr open sw sig
• Lf turn sig sw
• Logic
• Low ref
• Low tire pressure ind
• Nca
• Off
• Open
• Park
• Park brake switch (lower front of park brake handle)
• Park brk sw sig
• Pk lmp sw on sig
• Pnk
• Radio
• Radio class 2 serial data
• Remote control door lock receiver (rcdlr) (right side of dash)
• Rf turn sig sw
• Rfa class 2 serial data
• Right
• Right turn ind
• Seat belt ind
• Tan
• Traction off ind
• Turn signal/ multi-function switch
• Underhood fuse block (on right side of engine compt) x1