WARNING SYSTEMS – Chevrolet Venture 2005 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Warning Systems Wiring Diagram for Chevrolet Venture 2005

List of elements for Warning Systems Wiring Diagram for Chevrolet Venture 2005:

• (at right side of dash) g200
• Accessory voltage
• Battery
• Body control module (bcm) (below right side of dash)
• C12
• C13
• C14
• C15
• Chime control
• Chime ctrl
• Ctsy lamp fuse 10a
• D12
• Driver door lock actuator
• Driver's door sw signal
• Driver's seat belt switch (inside right half of driver's seat belt)
• Engine controls system
• Ext lamps off input
• Exterior lights system
• G301 (at lower left "b" pillar)
• G302 (at base of right "b" pillar)
• Ground
• Head
• Headlamp switch
• Hot at all times
• Hot in accy or run
• Hot in run, bulb test or start
• I/p fuse block (right side of dash, in right front door opening)
• Ign
• Ign 1 fuse 10a
• Ignition 1 voltage
• Ignition key alarm switch (closed w/key in ignition)
• Ignition key switch input
• Instrument panel cluster (ipc)
• Left seat belt switch
• Logic
• Mall/ cluster fuse 10a
• Nca
• Off
• Park
• Park lp fuse 20a
• Pnk
• Power distribution system
• Powertrain control module (pcm) (secured in air cleaner assembly, left front of engine compartment)
• Rear object sensor control module (behind trim panel at right front of cargo area)
• S209
• S211
• S212
• S232 (in dash harness, near breakout for radio)
• S233 (in dash harness, near breakout for radio)
• S282 (in dash harness, near breakout for cigar lighter)
• S303
• S304 (in body harness, near breakout for inflatable restraint & diagnostic module)
• S333
• S504
• Seat belt ind volt
• Seat belt indicator
• Tan
• Turn signal/ multifunction switch
• Underhood fuse block (above battery)
• Vehicle speed signal
• Vss
• W/ valve van
• W/o valve van