AUTOMOTIVE ELECTRICIANS PORTAL

WARNING SYSTEMS – Infiniti FX45 2004 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Chime Wiring Diagram for Infiniti FX45 2004

Chime Wiring Diagram for Infiniti FX45 2004 https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html Automotive Electricians Portal FZCO Automotive Electricians Portal FZCO
Download PDF file

List of elements for Chime Wiring Diagram for Infiniti FX45 2004:

  • (behind instrument cluster) m45
  • (on floor near driver seat) b15
  • 15a
  • 61a
  • 8a m1
  • B14
  • Bat (f/l)
  • Bat (fuse)
  • Batt
  • Belt ind
  • Body control module (bcm) (behind left kick panel)
  • Buzzer
  • Can-h
  • Can-l
  • Comb sw in 1
  • Comb sw in 2
  • Comb sw in 3
  • Comb sw in 4
  • Comb sw in 5
  • Comb sw out 1
  • Comb sw out 2
  • Comb sw out 3
  • Comb sw out 4
  • Comb sw out 5
  • Combination meter
  • Combination switch
  • Computer data lines system
  • Door ind
  • Door sw (dr)
  • Driver side front door switch
  • Driver side front power seat
  • Fuse 10a
  • Fuse 15a
  • Fuse block (j/b) (behind left kick panel)
  • Fuse, fusible link & relay block (right rear of engine compt)
  • Fusible link m 50a
  • Gnd
  • Gnd (power)
  • Gnd (signal)
  • Hot at all times
  • Hot in on or start
  • Ign sw
  • Ignition knob switch
  • Input 1
  • Input 2
  • Input 3
  • Input 4
  • Input 5
  • Inserted
  • Intelligent ket unit (if equipped) (behind left eng of dash)
  • Joint connector 7 (early production) (base of left "b" pillar)
  • Key sw
  • Key switch
  • Key switch & ignition knob switch (w/ intelligent key)
  • M45 (behind instrument cluster)
  • Output 1
  • Output 2
  • Output 3
  • Output 4
  • Output 5
  • Push sw
  • Pushed
  • Red
  • Removed
  • Rx (comb meter)
  • Seat belt buckle switch
  • Tx (comb meter)
  • Unified meter & a/c amplifier (behind center console)
  • Unified meter control unit
  • W/ intelligent key
  • W/o intelligent key
  • Withdrawn

Tire Pressure Monitoring Wiring Diagram for Infiniti FX45 2004

Tire Pressure Monitoring Wiring Diagram for Infiniti FX45 2004 https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html Automotive Electricians Portal FZCO Automotive Electricians Portal FZCO
Get access to all wiring diagrams of the carDownload PDF file

List of elements for Tire Pressure Monitoring Wiring Diagram for Infiniti FX45 2004:

  • (behind instrument cluster) m45
  • 12a
  • 15a
  • 5a m1
  • Acc
  • Ant input
  • Antenna
  • Bat (f/l)
  • Bat (fuse)
  • Batt
  • Body control module (bcm) (behind left kick panel)
  • Can-h
  • Can-l
  • Combination meter
  • Computer data lines system
  • Data link connector (lower left side of dash)
  • Diag-id input
  • Display control unit (right side of dash)
  • Exterior lights system
  • Flsher output (left)
  • Flsher output (right)
  • Fuse & fusible link block (right rear of engine compartment)
  • Fuse 10a
  • Fuse 15a
  • Fuse block (j/b) (behind left kick panel)
  • Fusible link m 50a
  • Gnd
  • Gnd (power)
  • Gnd (signal)
  • Hazard
  • Hazard sw
  • Hot at all times
  • Hot in acc or on
  • Hot in on or start
  • Ign
  • Ign sw
  • Low tire pressure warning control unit (right side of dash)
  • M20
  • M45 (behind instrument cluster)
  • M55
  • M56
  • M74
  • M85 (right end of dash)
  • Nca
  • R102
  • Red
  • Rx (comb meter)
  • Tire pressure ind
  • Tire pressure sensor
  • Tire pressure warning check switch
  • Tx (comb meter)
  • Unified meter & a/c amplifier (behind center console)
  • Unified meter control unit