WARNING SYSTEMS – Infiniti M35 2007 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Chime Wiring Diagram for Infiniti M35 2007

List of elements for Chime Wiring Diagram for Infiniti M35 2007:

• 15a
• 1b m5
• 4b m5
• Air bag diagnosis
• B40 (at left "c" pillar)
• Bat
• Bat (f/l)
• Bat (fuse)
• Batt
• Body control module (bcm) (behind right side of dash)
• Buckle sw
• Buzzer
• Can-h
• Can-l
• Comb sw in 1
• Comb sw in 2
• Comb sw in 3
• Comb sw in 4
• Comb sw in 5
• Comb sw out 1
• Comb sw out 2
• Comb sw out 3
• Comb sw out 4
• Comb sw out 5
• Combination meter
• Combination switch
• Computer data lines system
• Control unit (if equipped) (left side of luggage compt)
• Door ind
• Door sw (dr)
• Driver side front door switch (at left "b" pillar)
• Driver side front seat
• Fuse 1 10a
• Fuse 12 10a
• Fuse 14 10a
• Fuse 19 10a
• Fuse 21 10a
• Fuse 22 10a
• Fuse block (j/b) (behind left kick panel)
• Fuse, fusible line & relay box (right rear of engine compt)
• Fusible link f 50a
• Gnd
• Gnd (power)
• Hot at all times
• Hot in on or start
• Ign
• Ind
• Input 1
• Input 2
• Input 3
• Input 4
• Input 5
• Intelligent key unit (behind left kick panel)
• Key slot
• Key sw sig
• M147
• M16 (behind left end of dash)
• M32
• M64
• M65
• M70 (right end of dash)
• Nca
• Output 1
• Output 2
• Output 3
• Output 4
• Output 5
• Pnk
• Pre-crash seat belt
• Red
• Rx (comb meter)
• Seat belt
• Seat belt buckle switch
• Seat belt ind
• Sensor unit (under center console)
• Tx (comb meter)
• Unified meter & a/c amplifier (behind center console)
• Unified meter control unit

Lane Departure Warning Wiring Diagram for Infiniti M35 2007

List of elements for Lane Departure Warning Wiring Diagram for Infiniti M35 2007:

• Buzzer
• Can-h
• Can-l
• Combination meter
• Computer data lines system
• Failure led
• Fuse 12 10a
• Fuse 21 10a
• Fuse block (j/b) (behind left kick panel)
• Gnd
• Gnd housing
• Gnd pcb
• Hot at all times
• Hot in on or start
• Ign
• Ill
• Ind
• Interior lights system
• Ldw camera unit (front of roof)
• Ldw chime (behind left side of dash)
• Ldw ind
• Ldw switch
• M16 (behind left end of dash)
• M4 2a
• M5 4b
• M70 (right end of dash)
• Off
• Pnk
• Signal
• Switch input
• System on

Tire Pressure Monitoring Wiring Diagram for Infiniti M35 2007

List of elements for Tire Pressure Monitoring Wiring Diagram for Infiniti M35 2007:

• (behind center console) unified meter & a/c amplifier
• (j/b) (behind left kick panel)
• 4b m4
• Batt
• Body control module (behind right side of dash)
• Can h
• Can l
• Combination meter
• Computer data lines system
• Data fl
• Data fr
• Data rl
• Data rr
• Exterior lights system
• Fuse 10a
• Fuse block
• Grd
• Grd fl
• Grd fr
• Grd rl
• Grd rr
• Ground
• Hazard
• Hot at all times
• Hot in on or start
• Hzd sw
• Ign
• L hzd
• Left front tire pressure receiver (in left front wheelwell)
• Left rear tire pressure receiver (in left rear wheelwell)
• Low tire pressure warning control unit (behind left side of dash)
• M16 (behind left end of dash)
• M19
• M64
• M65
• Pnk
• R hzd
• Red
• Right front tire pressure receiver (in right front wheelwell)
• Right rear tire pressure receiver (in right rear wheelwell)
• Rssi
• Rssi fl
• Rssi fr
• Rssi rl
• Rssi rr
• Sig
• Tire pressure ind
• Tire pressure warning check connector (under left side of dash)
• Trg sw mode
• Unified meter control unit
• Vcc fl
• Vcc fr
• Vcc rl
• Vcc rr