WARNING SYSTEMS – Toyota 4Runner Limited 2008 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Chime Wiring Diagram for Toyota 4Runner Limited 2008

List of elements for Chime Wiring Diagram for Toyota 4Runner Limited 2008:

74

• (behind right center of dash) junction connector 25
• (below left front seat)
• (on rear of right cylinder head) (4.0l) ee
• A j43
• A32
• A33
• Acc
• Acc fuse 7.5a
• Air bag sensor assembly (below center of dash)
• Becu
• Bgnd
• Body ecu
• Bsw
• Buzzer
• C j15
• C10
• Center j/b (behind right center of dash)
• Combination meter
• Dbkl
• Dcty
• Dcy2
• Dome fuse 10a
• Door ind
• Driver side j/b (behind lower left end of dash)
• Driver's seat belt ind
• Drlp
• Ecu-b fuse 10a
• Ecu-ig fuse 10a
• Ed (4.7l) (on left cylinder head)
• Engine room r/b (on left side of engine compt)
• Fsr+
• Fsr-
• Gauge fuse 7.5a
• Gnd1
• Gnd2
• Hot at all times
• Hot in acc or on
• Hot in on or start
• Ig+
• Ig1 fuse 15a
• J14 b
• J18 e
• J19
• J20 d
• J21
• J29
• J30
• J43
• J44 a
• Junction connector 14 & 15 (behind instrument cluster)
• Junction connector 15 (behind instrument cluster)
• Junction connector 18 & 19 (behind instrument cluster)
• Junction connector 20 & 21 (behind instrument cluster)
• Junction connector 20 (behind instru- ment cluster)
• Junction connector 29 & 30 (behind right end of dash)
• Junction connector 43 & 44 (under left front seat)
• Junction connector 5 (behind right kick panel)
• Junction connector 53 (under left front seat)
• Junction connector 7 (behind left end of dash)
• Junction connector 8 & 9 (behind instrument cluster)
• K j44
• Ksw
• Kswo
• Left buckle switch (on left seat belt buckle)
• Left front door courtesy switch (in left "b" pillar)
• Occupant classification ecu (under front passenger's seat)
• Passenger seat belt warning light
• Pbew
• Red
• Right buckle switch (on right seat belt buckle)
• Sig
• Unlock warning switch (left side of dash)
• W/ memory
• W/o memory

Tire Pressure Monitoring Wiring Diagram for Toyota 4Runner Limited 2008

List of elements for Tire Pressure Monitoring Wiring Diagram for Toyota 4Runner Limited 2008:

47

• (on rear of right cylinder head) (4.0l) ee
• +5v
• C10
• Center j/b (behind right center of dash)
• Combination
• Data link connector 3 (below left side of dash)
• Dome fuse 10a
• Driver side j/b (behind lower left end of dash)
• Ecu-ig fuse 10a
• Ed (4.7l) (on left cylinder head)
• Engine control module (behind right end of dash)
• Engine room r/b (on left side of engine compt)
• Gauge fuse 7.5a
• Gnd
• Gnd2
• Hot at all times
• Hot in on or start
• Ind
• J/c 12 (behind instrument cluster)
• J/c 18 (behind instrument cluster)
• J/c 20 (behind instrument cluster)
• J/c 29 & 30 (behind right end of dash)
• J/c 31 & 32 (behind right end of dash)
• J/c 35 & 36 (behind right end of dash)
• J/c 7 (behind left end of dash)
• J/c 8 & 9 (behind instrument cluster)
• J28
• J29
• J30
• J31
• J32
• J35
• J36
• K11
• Meter
• Rda
• Red
• Rf5v
• Sil
• Skid control ecu with actuator (left rear of engine compartment)
• Sp1
• Spd
• Speedometer
• Tach
• Tire pressure ind
• Tire pressure monitor ecu (right side of dash)
• Tire pressure warning antenna & receiver (top center rear of roof)