WIPER/WASHER – Cadillac Catera 2000 – SYSTEM WIRING DIAGRAMS

WIPER/WASHER

Wiper/Washer Wiring Diagram for Cadillac Catera 2000

List of elements for Wiper/Washer Wiring Diagram for Cadillac Catera 2000:

• (dash harness, near ground breakout, on steering column support, near relay box) s223
• (dash harness, near ground breakout, on steering column support, near relay box) s224
• (windshield washer nozzle heater harness, approximately 68 cm (29 in) from in-line connector between dash harness to windshield washer nozzle heater harness, right rear of engine compartment) s145
• 68 cm (29 in) from in-line connector between dash harness to windshield washer nozzle heater harness, right rear of engine compartment)
• B810
• Body control module (bcm) (mounted on right "a" pillar, behind trim panel)
• Clamp 15 fuse 14 10a
• D13
• Delay (mist)
• Ecb
• Fast wiper input
• Fuse block (mounted to dash, on lower left side of steering column)
• G111 (under battery tray)
• Gauge cluster
• High
• Hot in on or start
• Instrument cluster system
• Int
• Interval switch
• Left windshield washer nozzle
• Low
• Low washer fluid indicator
• M808
• Nca
• Off
• Position switch
• Position switch (closes to ground when wipers are in park position)
• Right windshield washer nozzle
• S104 (body harness, approximately 71 cm (28 in) from grommet, towards ebtcm branch breakout)
• S137
• Slow input & interval
• Solid state
• Washer
• Windshield washer pump (in washer solvent reservoir)
• Windshield washer solvent level switch (inside windshield washer solvent reservoir)
• Windshield wiper & windshield washer switch
• Windshield wiper motor (center rear of engine compartment)
• Windshield wiper motor relay (on left front of engine compartment, in ecm housing)
• Wiper fuse 9 30a