CRUISE CONTROL – Isuzu Rodeo Sport 2002 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Isuzu Rodeo Sport 2002

List of elements for Cruise Control Wiring Diagram for Isuzu Rodeo Sport 2002:

• (left side of intake manifold)
• A/t mode switch (left side of trans)
• Acceleration position sensor assembly (above accelerator pedal)
• Acceleration sensors
• Anti-lock brakes & transmission systems
• Ap sen1 gnd
• Ap sen2 gnd
• Ap sensor 1
• Ap sensor 2
• Ap sensor 3
• Aps3 gnd
• Brake sw in
• Brake switch (on brake pedal support)
• C-16 (left rear corner of engine compt, on inner fender panel)
• Cancel
• Cb-11 meter fuse 15a
• Cb-12 engine ig fuse 15a
• Cb-14 back-up/ turn light fuse 15a
• Cb-6 stop light fuse 15a
• Clutch switch (on clutch pedal support)
• Cruise brake
• Cruise control main switch
• Cruise control res/acc switch
• Cruise lmp
• Cruise set light
• Cruise sw
• Dash fuse box (behind dash, left of steering column)
• Drive input
• E-21
• E-22
• E-28
• E-28 (left side of intake manifold)
• E-30 (right side of intake manifold)
• Eb-17 ecm fuse 30a
• Ecm or pcm main relay (in fuse/ relay box)
• Engine or powertrain control module (left rear of engine compartment)
• Fuse/ relay box (right side of engine compt)
• Gnd
• Hot at all times
• Hot in on or start
• I-9
• Ign feed
• Illum
• Interior lights
• Meter assembly
• On ind
• On switch
• Red
• Ref volt
• Res/acc in
• Set/cst
• Th val mtr
• Throttle position sensor 1
• Throttle position sensor 2
• Throttle val
• Throttle valve assembly (on throttle body assembly)
• Throttle valve motor
• Tps 1 sign
• Tps1 gnd
• Tps2 gnd
• Tps2 sign
• Vehicle speed sensor (rear of transmission)
• Vss in