GROUND DISTRIBUTION – Jeep Wrangler SE 1997 – SYSTEM WIRING DIAGRAMS

GROUND DISTRIBUTION

Ground Distribution Wiring Diagram (1 of 2) for Jeep Wrangler SE 1997

List of elements for Ground Distribution Wiring Diagram (1 of 2) for Jeep Wrangler SE 1997:

• (behind left headlamp)
• (in pdc) abs pump motor relay
• (in pdc) abs system relay
• (left rear of instrument panel)
• (left side of dash panel)
• (rear of generator)
• (right rear of engine block)
• (right rear of instrument panel)
• (w/ abs or drl) underhood lamp
• (w/ abs) (center of dash panel)
• (w/o abs & underhood lamp
• A/c- heater control
• Abs pump motor
• Airbag control module
• Anti-lock brake controller
• B19
• Battery
• Blower motor relay
• Blower motor resistor block
• C114
• C201
• C217
• C218
• C223
• Center high mounted stop lamp
• Cigar lighter/ power outlet
• Daytime running lamp module
• Fog lamp switch
• G106
• G116
• G117
• G119
• G121
• G201
• G202
• G203 (right kick panel)
• Generator
• Head- lamp switch
• Horn
• Instrument cluster
• Lamp breakout)
• Left fog lamp
• Left front park/turn signal lamp
• Left head- lamp
• Rear washer pump motor
• Rear window defogger
• Rear window defogger switch
• Rear wiper motor
• Rear wiper/ washer switch
• Right fog lamp
• Right front park/turn signal lamp
• Right head- lamp
• S106 (w/ abs and/or drl) (engine harness, left rear of engine compt, near breakout for ground g116)
• S117 (engine harness, front of engine compt, near breakout for left park/turn signal lamp)
• S125 (engine harness, near breakout for left park/ turn signal lamp)
• S125 (engine harness, near breakout for right park/ turn signal lamp)
• S203 (i/p harness, center rear of i/p)
• S207 (i/p harness, near cigar lighter breakout)
• S209 (i/p harness, in radio breakout)
• S309 (body harness, front of left rear wheel well)
• S400 (w/ hard top) (rear wiper harness, near rear wiper motor connector)
• Seat belt switch
• W/ fog lamps
• W/o fog lamps
• Windshield washer pump motor

Ground Distribution Wiring Diagram (2 of 2) for Jeep Wrangler SE 1997

List of elements for Ground Distribution Wiring Diagram (2 of 2) for Jeep Wrangler SE 1997:

• (2.5l) power steering pressure switch
• (in pdc) engine starter motor relay
• (not used)
• (right rear of of engine block)
• 4wd switch
• A/t
• A31
• A32
• Accessory relay
• C150
• C154
• C318
• Combination flasher
• D13
• Data link connector
• Downstream heated oxygen sensor
• Fog lamp relay
• Fuel pump module
• Fuse 10a
• Fuse block
• G117
• G200 (left kick panel)
• Ignition switch
• Left door ajar switch
• M/t
• Manual transmission jumper
• Powertrain control module
• Prndl lamp
• Right door ajar switch
• S130 (engine harness, right rear of cylinder head)
• S132 (engine harness, right rear of cylinder head)
• S134 (engine harness, near breakout for camshaft position sensor)
• S300 (cowl panel harness, in breakout for stop lamp switch)
• S304 (cowl panel harness, above brake pedal bracket)
• Stop lamp switch
• Upstream heated oxygen sensor
• Windshield wiper motor
• Windshield wiper/ washer switch