ANTI-THEFT – Pontiac G8 GT 2008 – SYSTEM WIRING DIAGRAMS

ANTI-THEFT

Forced Entry Wiring Diagram for Pontiac G8 GT 2008

List of elements for Forced Entry Wiring Diagram for Pontiac G8 GT 2008:

• (in body harness) j306
• (in body harness) j320
• 87a
• Body control module (bcm) (under left side of dash, right of steering column)
• Coax
• Computer data lines system
• Door lock/ window switch
• Dr lck ctrl
• Dr unlk
• Dr unlk cntrl
• Dr/lck fuse 3 25a
• Dr/lck relay 2
• Driver door latch
• Drvr dr/unlck relay 6
• Exterior lights system
• Fuel door release actuator
• Fuse suply volt
• G202 (behind left kick panel)
• G305 (behind left kick panel)
• G305 (in engine compt, on jump start post)
• G407 (under center of rear parcel shelf)
• G409 (in rear compartment on latch plate)
• Hood ajar switch
• Horn relay ctl
• Horns system
• Hot at all times
• Inst/disp/ rfa/dlc fuse 5 10a
• Instrument panel fuse block (behind left kick panel)
• J231
• J317 (in body harness)
• J404
• Keyless entry antenna
• Left rear door latch
• Pass dr/unlck relay 3
• Passenger door latch
• Pk lamp rly ctl
• Pwr dr lck
• Pwr dr unlk
• Rear compartment lid ajar switch
• Rear compartment lid latch assembly (center rear of lid)
• Rear fuse block (left side of rear compt)
• Remote control door lock receiver (rcdlr)
• Right rear door latch
• Suply volt
• Underhood fuse block (mounted to right front strut tower)
• X4 hood ajar sw
• X5 hood clsd sw
• X6 lftgt ajar sw
• X7 fuse suply volt

Pass-Key Wiring Diagram for Pontiac G8 GT 2008

List of elements for Pass-Key Wiring Diagram for Pontiac G8 GT 2008:

• (part of ignition key cylinder) theft deterrent control module
• Acc
• Batt ign 1 gnd
• Body control module (bcm) (under left side of dash, right of steering column)
• Computer data lines system
• Dlis/theft dtrnt fuse 12 2a
• G201 (behind right kick panel)
• Hot at all times
• Ignition switch
• Inst/disp/ rfa/dlc fuse 5 10a
• Instrument panel cluster
• Instrument panel fuse block (behind left kick panel)
• J217
• J220
• J221
• Logic
• Off
• Rear fuse block (left side of rear compt)
• Run
• Sec ind ctrl
• Security ind
• Serial data
• Serial data +
• Start