STARTING/CHARGING – Mitsubishi Eclipse Spyder GT 2010 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Mitsubishi Eclipse Spyder GT 2010

List of elements for Charging Wiring Diagram for Mitsubishi Eclipse Spyder GT 2010:

• 120a
• 40a
• 7.5a
• A15
• Acc
• B22
• Battery
• C202
• C215
• C24
• Combination meter
• Computer data lines system
• Cpu
• Engine compartment relay box (left side of engine compt)
• Engine control module (m/t) powertrain control module (a/t) (left side of engine compt, forward of relay box)
• Fuse 13
• Fuse 2 7.5a
• Fusible link 27 (on battery terminal)
• Fusible link 4
• G11 (2.4l: lower rear of engine) (3.8l: rear of engine)
• G15 (near left front shock tower)
• Generator
• Generator malfunction light ind
• Ignition switch
• Joint connector 2 (behind left side of dash)
• Junction block (under left end of dash)
• Lock
• Power distribution system
• Red
• Run
• Start
• Starting circuit

Starting Wiring Diagram for Mitsubishi Eclipse Spyder GT 2010

List of elements for Starting Wiring Diagram for Mitsubishi Eclipse Spyder GT 2010:

• (at left rear of engine compt, under relay box) g12
• A/t
• A15
• Acc
• B20
• Battery
• C24
• Engine compartment relay box (left side of engine compt)
• Fusible link 4 40a
• G11 (2.4l: lower rear of engine) (3.8l: rear of engine)
• G15 (near left front shock tower)
• Ignition switch
• Interlock switch (behind left side of dash)
• Lock
• M/t
• Nca
• Power distribution system
• Powertrain control module (a/t) engine control module (m/t) (left side of engine compt, forward of relay box)
• Run
• Start
• Starter
• Starter relay (in engine compt relay box)
• Transmission range switch (on automatic transaxle)